| Sylwester Nawrocki | 41f13ed | 2013-08-29 06:24:33 -0300 | [diff] [blame] | 1 | Samsung S5K6A3(YX) raw image sensor |
| 2 | --------------------------------- |
| 3 | |
| 4 | S5K6A3(YX) is a raw image sensor with MIPI CSI-2 and CCP2 image data interfaces |
| 5 | and CCI (I2C compatible) control bus. |
| 6 | |
| 7 | Required properties: |
| 8 | |
| 9 | - compatible : "samsung,s5k6a3"; |
| 10 | - reg : I2C slave address of the sensor; |
| 11 | - svdda-supply : core voltage supply; |
| 12 | - svddio-supply : I/O voltage supply; |
| 13 | - afvdd-supply : AF (actuator) voltage supply; |
| 14 | - gpios : specifier of a GPIO connected to the RESET pin; |
| 15 | - clocks : should contain list of phandle and clock specifier pairs |
| 16 | according to common clock bindings for the clocks described |
| 17 | in the clock-names property; |
| 18 | - clock-names : should contain "extclk" entry for the sensor's EXTCLK clock; |
| 19 | |
| 20 | Optional properties: |
| 21 | |
| 22 | - clock-frequency : the frequency at which the "extclk" clock should be |
| 23 | configured to operate, in Hz; if this property is not |
| 24 | specified default 24 MHz value will be used. |
| 25 | |
| 26 | The common video interfaces bindings (see video-interfaces.txt) should be |
| 27 | used to specify link to the image data receiver. The S5K6A3(YX) device |
| 28 | node should contain one 'port' child node with an 'endpoint' subnode. |
| 29 | |
| 30 | Following properties are valid for the endpoint node: |
| 31 | |
| 32 | - data-lanes : (optional) specifies MIPI CSI-2 data lanes as covered in |
| 33 | video-interfaces.txt. The sensor supports only one data lane. |