ARM: zynq: Allow UART1 to be used as DEBUG_LL console.
The main UART on the Xilinx ZC702 board is UART1, located at address
e0001000. Add a Kconfig option to select this device as the low-level
debugging port. This allows the really early boot printouts to reach
the USB serial adaptor on this board.
For consistency's sake, add a choice entry for UART0 even though it is
the the default if UART1 is not selected.
Signed-off-by: Nick Bowler <nbowler@elliptictech.com>
Tested-by: Josh Cartwright <josh.cartwright@ni.com>
Acked-by: Michal Simek <michal.simek@xilinx.com>
diff --git a/arch/arm/Kconfig.debug b/arch/arm/Kconfig.debug
index b0f3857..7754d51 100644
--- a/arch/arm/Kconfig.debug
+++ b/arch/arm/Kconfig.debug
@@ -132,6 +132,23 @@
their output to UART1 serial port on DaVinci TNETV107X
devices.
+ config DEBUG_ZYNQ_UART0
+ bool "Kernel low-level debugging on Xilinx Zynq using UART0"
+ depends on ARCH_ZYNQ
+ help
+ Say Y here if you want the debug print routines to direct
+ their output to UART0 on the Zynq platform.
+
+ config DEBUG_ZYNQ_UART1
+ bool "Kernel low-level debugging on Xilinx Zynq using UART1"
+ depends on ARCH_ZYNQ
+ help
+ Say Y here if you want the debug print routines to direct
+ their output to UART1 on the Zynq platform.
+
+ If you have a ZC702 board and want early boot messages to
+ appear on the USB serial adaptor, select this option.
+
config DEBUG_DC21285_PORT
bool "Kernel low-level debugging messages via footbridge serial port"
depends on FOOTBRIDGE