| Datasheet: https://www.sensirion.com/file/datasheet_shtc1 |
| Datasheet: https://www.sensirion.com/file/datasheet_shtw1 |
| Datasheet: https://www.sensirion.com/file/datasheet_shtc3 |
| Johannes Winkelmann <johannes.winkelmann@sensirion.com> |
| This driver implements support for the Sensirion SHTC1, SHTW1, and SHTC3 |
| chips, a humidity and temperature sensor. Temperature is measured in degrees |
| celsius, relative humidity is expressed as a percentage. |
| The device communicates with the I2C protocol. All sensors are set to I2C |
| address 0x70. See Documentation/i2c/instantiating-devices.rst for methods to |
| There are two options configurable by means of shtc1_platform_data: |
| 1. blocking (pull the I2C clock line down while performing the measurement) or |
| non-blocking mode. Blocking mode will guarantee the fastest result but |
| the I2C bus will be busy during that time. By default, non-blocking mode |
| is used. Make sure clock-stretching works properly on your device if you |
| want to use blocking mode. |
| 2. high or low accuracy. High accuracy is used by default and using it is |