x86/hyperv: Initialize clockevents after LAPIC is initialized
With commit 4df4cb9e99f8, the Hyper-V direct-mode STIMER is actually
initialized before LAPIC is initialized: see
apic_intr_mode_init()
x86_platform.apic_post_init()
hyperv_init()
hv_stimer_alloc()
apic_bsp_setup()
setup_local_APIC()
setup_local_APIC() temporarily disables LAPIC, initializes it and
re-eanble it. The direct-mode STIMER depends on LAPIC, and when it's
registered, it can be programmed immediately and the timer can fire
very soon:
hv_stimer_init
clockevents_config_and_register
clockevents_register_device
tick_check_new_device
tick_setup_device
tick_setup_periodic(), tick_setup_oneshot()
clockevents_program_event
When the timer fires in the hypervisor, if the LAPIC is in the
disabled state, new versions of Hyper-V ignore the event and don't inject
the timer interrupt into the VM, and hence the VM hangs when it boots.
Note: when the VM starts/reboots, the LAPIC is pre-enabled by the
firmware, so the window of LAPIC being temporarily disabled is pretty
small, and the issue can only happen once out of 100~200 reboots for
a 40-vCPU VM on one dev host, and on another host the issue doesn't
reproduce after 2000 reboots.
The issue is more noticeable for kdump/kexec, because the LAPIC is
disabled by the first kernel, and stays disabled until the kdump/kexec
kernel enables it. This is especially an issue to a Generation-2 VM
(for which Hyper-V doesn't emulate the PIT timer) when CONFIG_HZ=1000
(rather than CONFIG_HZ=250) is used.
Fix the issue by moving hv_stimer_alloc() to a later place where the
LAPIC timer is initialized.
Fixes: 4df4cb9e99f8 ("x86/hyperv: Initialize clockevents earlier in CPU onlining")
Signed-off-by: Dexuan Cui <decui@microsoft.com>
Reviewed-by: Michael Kelley <mikelley@microsoft.com>
Link: https://lore.kernel.org/r/20210116223136.13892-1-decui@microsoft.com
Signed-off-by: Wei Liu <wei.liu@kernel.org>
1 file changed