swiotlb: Add swiotlb=noforce debug option
On architectures like arm64, swiotlb is tied intimately to the core
architecture DMA support. In addition, ZONE_DMA cannot be disabled.
To aid debugging and catch devices not supporting DMA to memory outside
the 32-bit address space, add a kernel command line option
"swiotlb=noforce", which disables the use of bounce buffers.
If specified, trying to map memory that cannot be used with DMA will
fail, and a rate-limited warning will be printed.
Note that io_tlb_nslabs is set to 1, which is the minimal supported
value.
Signed-off-by: Geert Uytterhoeven <geert+renesas@glider.be>
Signed-off-by: Konrad Rzeszutek Wilk <konrad.wilk@oracle.com>
diff --git a/lib/swiotlb.c b/lib/swiotlb.c
index a32dce6..9def738 100644
--- a/lib/swiotlb.c
+++ b/lib/swiotlb.c
@@ -106,8 +106,12 @@ setup_io_tlb_npages(char *str)
}
if (*str == ',')
++str;
- if (!strcmp(str, "force"))
+ if (!strcmp(str, "force")) {
swiotlb_force = SWIOTLB_FORCE;
+ } else if (!strcmp(str, "noforce")) {
+ swiotlb_force = SWIOTLB_NO_FORCE;
+ io_tlb_nslabs = 1;
+ }
return 0;
}
@@ -543,8 +547,15 @@ static phys_addr_t
map_single(struct device *hwdev, phys_addr_t phys, size_t size,
enum dma_data_direction dir, unsigned long attrs)
{
- dma_addr_t start_dma_addr = phys_to_dma(hwdev, io_tlb_start);
+ dma_addr_t start_dma_addr;
+ if (swiotlb_force == SWIOTLB_NO_FORCE) {
+ dev_warn_ratelimited(hwdev, "Cannot do DMA to address %pa\n",
+ &phys);
+ return SWIOTLB_MAP_ERROR;
+ }
+
+ start_dma_addr = phys_to_dma(hwdev, io_tlb_start);
return swiotlb_tbl_map_single(hwdev, start_dma_addr, phys, size,
dir, attrs);
}
@@ -721,6 +732,9 @@ static void
swiotlb_full(struct device *dev, size_t size, enum dma_data_direction dir,
int do_panic)
{
+ if (swiotlb_force == SWIOTLB_NO_FORCE)
+ return;
+
/*
* Ran out of IOMMU space for this operation. This is very bad.
* Unfortunately the drivers cannot handle this operation properly.