MIPS: KVM: Add master disable count interface
Expose two new virtual registers to userland via the
KVM_{GET,SET}_ONE_REG ioctls.
KVM_REG_MIPS_COUNT_CTL is for timer configuration fields and just
contains a master disable count bit. This can be used by userland to
freeze the timer in order to read a consistent state from the timer
count value and timer interrupt pending bit. This cannot be done with
the CP0_Cause.DC bit because the timer interrupt pending bit (TI) is
also in CP0_Cause so it would be impossible to stop the timer without
also risking a race with an hrtimer interrupt and having to explicitly
check whether an interrupt should have occurred.
When the timer is re-enabled it resumes without losing time, i.e. the
CP0_Count value jumps to what it would have been had the timer not been
disabled, which would also be impossible to do from userland with
CP0_Cause.DC. The timer interrupt also cannot be lost, i.e. if a timer
interrupt would have occurred had the timer not been disabled it is
queued when the timer is re-enabled.
This works by storing the nanosecond monotonic time when the master
disable is set, and using it for various operations instead of the
current monotonic time (e.g. when recalculating the bias when the
CP0_Count is set), until the master disable is cleared again, i.e. the
timer state is read/written as it would have been at that time. This
state is exposed to userland via the read-only KVM_REG_MIPS_COUNT_RESUME
virtual register so that userland can determine the exact time the
master disable took effect.
This should allow userland to atomically save the state of the timer,
and later restore it.
Signed-off-by: James Hogan <james.hogan@imgtec.com>
Cc: Paolo Bonzini <pbonzini@redhat.com>
Cc: Gleb Natapov <gleb@kernel.org>
Cc: kvm@vger.kernel.org
Cc: Ralf Baechle <ralf@linux-mips.org>
Cc: linux-mips@linux-mips.org
Cc: David Daney <david.daney@cavium.com>
Cc: Sanjay Lal <sanjayl@kymasys.com>
Signed-off-by: Paolo Bonzini <pbonzini@redhat.com>
diff --git a/arch/mips/include/asm/kvm_host.h b/arch/mips/include/asm/kvm_host.h
index 75ed94a..1deeaec 100644
--- a/arch/mips/include/asm/kvm_host.h
+++ b/arch/mips/include/asm/kvm_host.h
@@ -405,12 +405,16 @@
u32 io_gpr; /* GPR used as IO source/target */
struct hrtimer comparecount_timer;
+ /* Count timer control KVM register */
+ uint32_t count_ctl;
/* Count bias from the raw time */
uint32_t count_bias;
/* Frequency of timer in Hz */
uint32_t count_hz;
/* Dynamic nanosecond bias (multiple of count_period) to avoid overflow */
s64 count_dyn_bias;
+ /* Resume time */
+ ktime_t count_resume;
/* Period of timer tick in ns */
u64 count_period;
@@ -714,6 +718,8 @@
void kvm_mips_write_count(struct kvm_vcpu *vcpu, uint32_t count);
void kvm_mips_write_compare(struct kvm_vcpu *vcpu, uint32_t compare);
void kvm_mips_init_count(struct kvm_vcpu *vcpu);
+int kvm_mips_set_count_ctl(struct kvm_vcpu *vcpu, s64 count_ctl);
+int kvm_mips_set_count_resume(struct kvm_vcpu *vcpu, s64 count_resume);
void kvm_mips_count_enable_cause(struct kvm_vcpu *vcpu);
void kvm_mips_count_disable_cause(struct kvm_vcpu *vcpu);
enum hrtimer_restart kvm_mips_count_timeout(struct kvm_vcpu *vcpu);