zd1211rw: fix ack_pending in filter_ack causing tx-packet ordering problem on monitor
For reasons not very clear yet to me, filter_ack leaves matching tx-packet
pending with 'ack_pending'. This causes tx-packet to be passed back to upper
layer after next packet has been transfered and tx-packets might end up
coming come out of monitor interface in wrong order vs. rx.
Because of this when enable AP-mode, hostapd monitor interface would get
packets in wrong order causing problems in WPA association.
So don't use mac->ack_pending when in AP-mode.
Signed-off-by: Jussi Kivilinna <jussi.kivilinna@mbnet.fi>
Signed-off-by: John W. Linville <linville@tuxdriver.com>
diff --git a/drivers/net/wireless/zd1211rw/zd_mac.c b/drivers/net/wireless/zd1211rw/zd_mac.c
index ab0d1b9..84ac95e 100644
--- a/drivers/net/wireless/zd1211rw/zd_mac.c
+++ b/drivers/net/wireless/zd1211rw/zd_mac.c
@@ -799,6 +799,13 @@
mac->ack_pending = 1;
mac->ack_signal = stats->signal;
+
+ /* Prevent pending tx-packet on AP-mode */
+ if (mac->type == NL80211_IFTYPE_AP) {
+ skb = __skb_dequeue(q);
+ zd_mac_tx_status(hw, skb, mac->ack_signal, NULL);
+ mac->ack_pending = 0;
+ }
}
spin_unlock_irqrestore(&q->lock, flags);