btrfs: qgroup: Use delayed subtree rescan for balance
Before this patch, qgroup code traces the whole subtree of subvolume and
reloc trees unconditionally.
This makes qgroup numbers consistent, but it could cause tons of
unnecessary extent tracing, which causes a lot of overhead.
However for subtree swap of balance, just swap both subtrees because
they contain the same contents and tree structure, so qgroup numbers
won't change.
It's the race window between subtree swap and transaction commit could
cause qgroup number change.
This patch will delay the qgroup subtree scan until COW happens for the
subtree root.
So if there is no other operations for the fs, balance won't cause extra
qgroup overhead. (best case scenario)
Depending on the workload, most of the subtree scan can still be
avoided.
Only for worst case scenario, it will fall back to old subtree swap
overhead. (scan all swapped subtrees)
[[Benchmark]]
Hardware:
VM 4G vRAM, 8 vCPUs,
disk is using 'unsafe' cache mode,
backing device is SAMSUNG 850 evo SSD.
Host has 16G ram.
Mkfs parameter:
--nodesize 4K (To bump up tree size)
Initial subvolume contents:
4G data copied from /usr and /lib.
(With enough regular small files)
Snapshots:
16 snapshots of the original subvolume.
each snapshot has 3 random files modified.
balance parameter:
-m
So the content should be pretty similar to a real world root fs layout.
And after file system population, there is no other activity, so it
should be the best case scenario.
| v4.20-rc1 | w/ patchset | diff
-----------------------------------------------------------------------
relocated extents | 22615 | 22457 | -0.1%
qgroup dirty extents | 163457 | 121606 | -25.6%
time (sys) | 22.884s | 18.842s | -17.6%
time (real) | 27.724s | 22.884s | -17.5%
Signed-off-by: Qu Wenruo <wqu@suse.com>
Signed-off-by: David Sterba <dsterba@suse.com>
4 files changed