Documentation: of: Fix grammar usage in graph bindings
Some minor tweaks to the language and formatting used in the
documentation identified while I was reading up on the subject matter.
Signed-off-by: Kieran Bingham <kieran.bingham+renesas@ideasonboard.com>
Acked-by: Philipp Zabel <p.zabel@pengutronix.de>
Signed-off-by: Rob Herring <robh@kernel.org>
diff --git a/Documentation/devicetree/bindings/graph.txt b/Documentation/devicetree/bindings/graph.txt
index fcb1c6a..0415e2c 100644
--- a/Documentation/devicetree/bindings/graph.txt
+++ b/Documentation/devicetree/bindings/graph.txt
@@ -34,7 +34,7 @@
If more than one port is present in a device node or there is more than one
endpoint at a port, or a port node needs to be associated with a selected
hardware interface, a common scheme using '#address-cells', '#size-cells'
-and 'reg' properties is used number the nodes.
+and 'reg' properties is used to number the nodes.
device {
...
@@ -89,9 +89,9 @@
Each endpoint should contain a 'remote-endpoint' phandle property that points
to the corresponding endpoint in the port of the remote device. In turn, the
-remote endpoint should contain a 'remote-endpoint' property. If it has one,
-it must not point to another than the local endpoint. Two endpoints with their
-'remote-endpoint' phandles pointing at each other form a link between the
+remote endpoint should contain a 'remote-endpoint' property. If it has one, it
+must not point to anything other than the local endpoint. Two endpoints with
+their 'remote-endpoint' phandles pointing at each other form a link between the
containing ports.
device-1 {
@@ -110,13 +110,12 @@
};
};
-
Required properties
-------------------
If there is more than one 'port' or more than one 'endpoint' node or 'reg'
-property is present in port and/or endpoint nodes the following properties
-are required in a relevant parent node:
+property present in the port and/or endpoint nodes then the following
+properties are required in a relevant parent node:
- #address-cells : number of cells required to define port/endpoint
identifier, should be 1.