net: dsa: microchip: look for phy-mode in port nodes
Documentation/devicetree/bindings/net/dsa/dsa.txt says that the phy-mode
property should be specified on port nodes. However, the microchip
drivers read it from the switch node.
Let the driver use the per-port property and fall back to the old
location with a warning.
Fix in-tree users.
Signed-off-by: Helmut Grohne <helmut.grohne@intenta.de>
Link: https://lore.kernel.org/netdev/20200617082235.GA1523@laureti-dev/
Acked-by: Alexandre Belloni <alexandre.belloni@bootlin.com>
Signed-off-by: David S. Miller <davem@davemloft.net>
diff --git a/arch/arm/boot/dts/at91-sama5d2_icp.dts b/arch/arm/boot/dts/at91-sama5d2_icp.dts
index 8d19925..6783cf1 100644
--- a/arch/arm/boot/dts/at91-sama5d2_icp.dts
+++ b/arch/arm/boot/dts/at91-sama5d2_icp.dts
@@ -116,7 +116,6 @@ spi2: spi@400 {
switch0: ksz8563@0 {
compatible = "microchip,ksz8563";
reg = <0>;
- phy-mode = "mii";
reset-gpios = <&pioA PIN_PD4 GPIO_ACTIVE_LOW>;
spi-max-frequency = <500000>;
@@ -140,6 +139,7 @@ port@2 {
reg = <2>;
label = "cpu";
ethernet = <&macb0>;
+ phy-mode = "mii";
fixed-link {
speed = <100>;
full-duplex;