spi: atmel: Remove needless bits_per_word and speed_hz tests
SPI core validates both bits_per_word and speed_hz transfer parameters and
defaults to spi->bits_per_word and spi->max_speed_hz in case these per
transfer parameters are not set. This makes possible to remove two if
statements and remove one code block that is never executed.
Signed-off-by: Jarkko Nikula <jarkko.nikula@linux.intel.com>
Acked-by: Nicolas Ferre <nicolas.ferre@atmel.com>
Signed-off-by: Mark Brown <broonie@kernel.org>
diff --git a/drivers/spi/spi-atmel.c b/drivers/spi/spi-atmel.c
index bf9ed38..1cc1f1e 100644
--- a/drivers/spi/spi-atmel.c
+++ b/drivers/spi/spi-atmel.c
@@ -871,14 +871,7 @@
* Calculate the lowest divider that satisfies the
* constraint, assuming div32/fdiv/mbz == 0.
*/
- if (xfer->speed_hz)
- scbr = DIV_ROUND_UP(bus_hz, xfer->speed_hz);
- else
- /*
- * This can happend if max_speed is null.
- * In this case, we set the lowest possible speed
- */
- scbr = 0xff;
+ scbr = DIV_ROUND_UP(bus_hz, xfer->speed_hz);
/*
* If the resulting divider doesn't fit into the
@@ -1300,14 +1293,12 @@
return -EINVAL;
}
- if (xfer->bits_per_word) {
- asd = spi->controller_state;
- bits = (asd->csr >> 4) & 0xf;
- if (bits != xfer->bits_per_word - 8) {
- dev_dbg(&spi->dev,
+ asd = spi->controller_state;
+ bits = (asd->csr >> 4) & 0xf;
+ if (bits != xfer->bits_per_word - 8) {
+ dev_dbg(&spi->dev,
"you can't yet change bits_per_word in transfers\n");
- return -ENOPROTOOPT;
- }
+ return -ENOPROTOOPT;
}
/*