Add hotplug support to mcp251x driver
Chip model can now be selected directly by matching the modalias name
(instead of filling the .model field in platform_data), and allows the
module to be auto-loaded. Previous behaviour is of course still supported.
Convert the two in-tree users to this feature (icontrol & zeus).
Tested on an Zeus platform (mcp2515).
Signed-off-by: Marc Zyngier <maz@misterjones.org>
Acked-by: Christian Pellegrin <chripell@fsfe.org>
Cc: Edwin Peer <epeer@tmtservices.co.za>
Acked-by: Wolfgang Grandegger <wg@grandegger.com>
Signed-off-by: David S. Miller <davem@davemloft.net>
diff --git a/arch/arm/mach-pxa/icontrol.c b/arch/arm/mach-pxa/icontrol.c
index 771137f..5ccb0ce 100644
--- a/arch/arm/mach-pxa/icontrol.c
+++ b/arch/arm/mach-pxa/icontrol.c
@@ -73,7 +73,6 @@
static struct mcp251x_platform_data mcp251x_info = {
.oscillator_frequency = 16E6,
- .model = CAN_MCP251X_MCP2515,
.board_specific_setup = NULL,
.power_enable = NULL,
.transceiver_enable = NULL
@@ -81,7 +80,7 @@
static struct spi_board_info mcp251x_board_info[] = {
{
- .modalias = "mcp251x",
+ .modalias = "mcp2515",
.max_speed_hz = 6500000,
.bus_num = 3,
.chip_select = 0,
@@ -90,7 +89,7 @@
.irq = gpio_to_irq(ICONTROL_MCP251x_nIRQ1)
},
{
- .modalias = "mcp251x",
+ .modalias = "mcp2515",
.max_speed_hz = 6500000,
.bus_num = 3,
.chip_select = 1,
@@ -99,7 +98,7 @@
.irq = gpio_to_irq(ICONTROL_MCP251x_nIRQ2)
},
{
- .modalias = "mcp251x",
+ .modalias = "mcp2515",
.max_speed_hz = 6500000,
.bus_num = 4,
.chip_select = 0,
@@ -108,7 +107,7 @@
.irq = gpio_to_irq(ICONTROL_MCP251x_nIRQ3)
},
{
- .modalias = "mcp251x",
+ .modalias = "mcp2515",
.max_speed_hz = 6500000,
.bus_num = 4,
.chip_select = 1,