gpio/aspeed-sgpio: don't enable all interrupts by default
Currently, the IRQ setup for the SGPIO driver enables all interrupts in
dual-edge trigger mode. Since the default handler is handle_bad_irq, any
state change on input GPIOs will trigger bad IRQ warnings.
This change applies sensible IRQ defaults: single-edge trigger, and all
IRQs disabled.
Signed-off-by: Jeremy Kerr <jk@codeconstruct.com.au>
Fixes: 7db47faae79b ("gpio: aspeed: Add SGPIO driver")
Reviewed-by: Joel Stanley <joel@jms.id.au>
Acked-by: Andrew Jeffery <andrew@aj.id.au>
Signed-off-by: Bartosz Golaszewski <bgolaszewski@baylibre.com>
diff --git a/drivers/gpio/gpio-aspeed-sgpio.c b/drivers/gpio/gpio-aspeed-sgpio.c
index 5d678db..a0eb00c 100644
--- a/drivers/gpio/gpio-aspeed-sgpio.c
+++ b/drivers/gpio/gpio-aspeed-sgpio.c
@@ -452,17 +452,15 @@ static int aspeed_sgpio_setup_irqs(struct aspeed_sgpio *gpio,
irq->parents = &gpio->irq;
irq->num_parents = 1;
- /* set IRQ settings and Enable Interrupt */
+ /* Apply default IRQ settings */
for (i = 0; i < ARRAY_SIZE(aspeed_sgpio_banks); i++) {
bank = &aspeed_sgpio_banks[i];
/* set falling or level-low irq */
iowrite32(0x00000000, bank_reg(gpio, bank, reg_irq_type0));
/* trigger type is edge */
iowrite32(0x00000000, bank_reg(gpio, bank, reg_irq_type1));
- /* dual edge trigger mode. */
- iowrite32(0xffffffff, bank_reg(gpio, bank, reg_irq_type2));
- /* enable irq */
- iowrite32(0xffffffff, bank_reg(gpio, bank, reg_irq_enable));
+ /* single edge trigger */
+ iowrite32(0x00000000, bank_reg(gpio, bank, reg_irq_type2));
}
return 0;