mmc: atmel-mci: adopt pinctrl support
Amend the atmel mci pin controller to optionally take a pin control
handle and set the state of the pins to:
- "default" on boot, resume and before performing an transfer.
- "sleep" on suspend().
This should make it possible to optimize energy usage for the pins
both for the suspend/resume cycle.
Signed-off-by: Wenyou Yang <wenyou.yang@atmel.com>
Signed-off-by: Ulf Hansson <ulf.hansson@linaro.org>
diff --git a/drivers/mmc/host/atmel-mci.c b/drivers/mmc/host/atmel-mci.c
index 4df1599..a7b59ba 100644
--- a/drivers/mmc/host/atmel-mci.c
+++ b/drivers/mmc/host/atmel-mci.c
@@ -39,6 +39,7 @@
#include <linux/atmel_pdc.h>
#include <linux/pm.h>
#include <linux/pm_runtime.h>
+#include <linux/pinctrl/consumer.h>
#include <asm/cacheflush.h>
#include <asm/io.h>
@@ -2568,6 +2569,8 @@
clk_disable_unprepare(host->mck);
+ pinctrl_pm_select_sleep_state(dev);
+
return 0;
}
@@ -2575,6 +2578,8 @@
{
struct atmel_mci *host = dev_get_drvdata(dev);
+ pinctrl_pm_select_default_state(dev);
+
return clk_prepare_enable(host->mck);
}
#endif