[SCSI] bnx2fc: Enable REC & CONF support for the session
Based on PRLI response, identify if the target is FCP-2 (seq level error
recovery) capable, and appropriately set the corresponding CONF, REC flags when
offloading the session.
Signed-off-by: Bhanu Prakash Gollapudi <bprakash@broadcom.com>
Signed-off-by: James Bottomley <JBottomley@Parallels.com>
diff --git a/drivers/scsi/bnx2fc/bnx2fc_hwi.c b/drivers/scsi/bnx2fc/bnx2fc_hwi.c
index ee1674b..fa263b5 100644
--- a/drivers/scsi/bnx2fc/bnx2fc_hwi.c
+++ b/drivers/scsi/bnx2fc/bnx2fc_hwi.c
@@ -279,6 +279,18 @@
ofld_req3.flags |= (((rdata->sp_features & FC_SP_FT_SEQC) ? 1 : 0) <<
FCOE_KWQE_CONN_OFFLOAD3_B_CONT_INCR_SEQ_CNT_SHIFT);
+ /*
+ * Info from PRLI response, this info is used for sequence level error
+ * recovery support
+ */
+ if (tgt->dev_type == TYPE_TAPE) {
+ ofld_req3.flags |= 1 <<
+ FCOE_KWQE_CONN_OFFLOAD3_B_CONF_REQ_SHIFT;
+ ofld_req3.flags |= (((rdata->flags & FC_RP_FLAGS_REC_SUPPORTED)
+ ? 1 : 0) <<
+ FCOE_KWQE_CONN_OFFLOAD3_B_REC_VALID_SHIFT);
+ }
+
/* vlan flag */
ofld_req3.flags |= (interface->vlan_enabled <<
FCOE_KWQE_CONN_OFFLOAD3_B_VLAN_FLAG_SHIFT);