ARM: pxa: Access SMEMC via virtual addresses
This is important because on PXA3xx, the physical mapping of SMEMC registers
differs from the one on PXA2xx. In order to get PCMCIA working on both PXA2xx
and PXA320, the PCMCIA driver was adjusted accordingly as well.
Also, various places in the kernel had to be patched to use
__raw_read/__raw_write.
Signed-off-by: Marek Vasut <marek.vasut@gmail.com>
Acked-by: Haojian Zhuang <haojian.zhuang@gmail.com>
Signed-off-by: Eric Miao <eric.y.miao@gmail.com>
diff --git a/arch/arm/mach-pxa/cpufreq-pxa2xx.c b/arch/arm/mach-pxa/cpufreq-pxa2xx.c
index 58093d9..6a7aeab 100644
--- a/arch/arm/mach-pxa/cpufreq-pxa2xx.c
+++ b/arch/arm/mach-pxa/cpufreq-pxa2xx.c
@@ -38,8 +38,10 @@
#include <linux/cpufreq.h>
#include <linux/err.h>
#include <linux/regulator/consumer.h>
+#include <linux/io.h>
#include <mach/pxa2xx-regs.h>
+#include <mach/smemc.h>
#ifdef DEBUG
static unsigned int freq_debug;
@@ -242,7 +244,7 @@
static void init_sdram_rows(void)
{
- uint32_t mdcnfg = MDCNFG;
+ uint32_t mdcnfg = __raw_readl(MDCNFG);
unsigned int drac2 = 0, drac0 = 0;
if (mdcnfg & (MDCNFG_DE2 | MDCNFG_DE3))
@@ -331,8 +333,8 @@
* we need to preset the smaller DRI before the change. If we're
* speeding up we need to set the larger DRI value after the change.
*/
- preset_mdrefr = postset_mdrefr = MDREFR;
- if ((MDREFR & MDREFR_DRI_MASK) > mdrefr_dri(new_freq_mem)) {
+ preset_mdrefr = postset_mdrefr = __raw_readl(MDREFR);
+ if ((preset_mdrefr & MDREFR_DRI_MASK) > mdrefr_dri(new_freq_mem)) {
preset_mdrefr = (preset_mdrefr & ~MDREFR_DRI_MASK);
preset_mdrefr |= mdrefr_dri(new_freq_mem);
}
@@ -370,7 +372,7 @@
3: nop \n\
"
: "=&r" (unused)
- : "r" (&MDREFR), "r" (cclkcfg),
+ : "r" (MDREFR), "r" (cclkcfg),
"r" (preset_mdrefr), "r" (postset_mdrefr)
: "r4", "r5");
local_irq_restore(flags);