Bluetooth: Fix updating scan mode in set_bredr()
Now that the connectable setting is also applicable for the LE side it's
possible that the HCI_CONNECTABLE flag is already set when changing the
BR/EDR setting from false to true while the controller is powered. In
this situation we need to update the BR/EDR scan mode to reflect the
setting. Additionally, since HCI_CONNECTABLE also applies to LE we must
not clear the HCI_CONNECTABLE flag when disabling bredr.
Signed-off-by: Johan Hedberg <johan.hedberg@intel.com>
Signed-off-by: Marcel Holtmann <marcel@holtmann.org>
diff --git a/net/bluetooth/mgmt.c b/net/bluetooth/mgmt.c
index 48aa239..0bad451 100644
--- a/net/bluetooth/mgmt.c
+++ b/net/bluetooth/mgmt.c
@@ -3640,7 +3640,6 @@
if (!hdev_is_powered(hdev)) {
if (!cp->val) {
- clear_bit(HCI_CONNECTABLE, &hdev->dev_flags);
clear_bit(HCI_DISCOVERABLE, &hdev->dev_flags);
clear_bit(HCI_SSP_ENABLED, &hdev->dev_flags);
clear_bit(HCI_LINK_SECURITY, &hdev->dev_flags);
@@ -3683,7 +3682,12 @@
set_bit(HCI_BREDR_ENABLED, &hdev->dev_flags);
hci_req_init(&req, hdev);
+
+ if (test_bit(HCI_CONNECTABLE, &hdev->dev_flags))
+ set_bredr_scan(&req);
+
hci_update_ad(&req);
+
err = hci_req_run(&req, set_bredr_complete);
if (err < 0)
mgmt_pending_remove(cmd);