usb: usb251xb: simplify reset helper
Currently the reset handler was always called to deassert the reset
line because assert the line was done during probe. Now if we want to
support pm by turn of the supply we need to call this routine twice and
the i2c_lock_bus is done twice too. To simplify that we can drop the
state and just do a reset in one go. So a future pm operation don't need
to lock the i2c bus twice.
Signed-off-by: Marco Felsch <m.felsch@pengutronix.de>
Reviewed-by: Richard Leitner <richard.leitner@skidata.com>
Tested-by: Richard Leitner <richard.leitner@skidata.com>
Link: https://lore.kernel.org/r/20190917144449.32739-4-m.felsch@pengutronix.de
Signed-off-by: Greg Kroah-Hartman <gregkh@linuxfoundation.org>
diff --git a/drivers/usb/misc/usb251xb.c b/drivers/usb/misc/usb251xb.c
index 0581916..bc031d3 100644
--- a/drivers/usb/misc/usb251xb.c
+++ b/drivers/usb/misc/usb251xb.c
@@ -263,20 +263,19 @@ static int usb251x_check_gpio_chip(struct usb251xb *hub)
}
#endif
-static void usb251xb_reset(struct usb251xb *hub, int state)
+static void usb251xb_reset(struct usb251xb *hub)
{
if (!hub->gpio_reset)
return;
i2c_lock_bus(hub->i2c->adapter, I2C_LOCK_SEGMENT);
- gpiod_set_value_cansleep(hub->gpio_reset, state);
+ gpiod_set_value_cansleep(hub->gpio_reset, 1);
+ usleep_range(1, 10); /* >=1us RESET_N asserted */
+ gpiod_set_value_cansleep(hub->gpio_reset, 0);
/* wait for hub recovery/stabilization */
- if (!state)
- usleep_range(500, 750); /* >=500us at power on */
- else
- usleep_range(1, 10); /* >=1us at power down */
+ usleep_range(500, 750); /* >=500us after RESET_N deasserted */
i2c_unlock_bus(hub->i2c->adapter, I2C_LOCK_SEGMENT);
}
@@ -294,7 +293,7 @@ static int usb251xb_connect(struct usb251xb *hub)
i2c_wb[0] = 0x01;
i2c_wb[1] = USB251XB_STATUS_COMMAND_ATTACH;
- usb251xb_reset(hub, 0);
+ usb251xb_reset(hub);
err = i2c_smbus_write_i2c_block_data(hub->i2c,
USB251XB_ADDR_STATUS_COMMAND, 2, i2c_wb);
@@ -344,7 +343,7 @@ static int usb251xb_connect(struct usb251xb *hub)
i2c_wb[USB251XB_ADDR_PORT_MAP_7] = hub->port_map7;
i2c_wb[USB251XB_ADDR_STATUS_COMMAND] = USB251XB_STATUS_COMMAND_ATTACH;
- usb251xb_reset(hub, 0);
+ usb251xb_reset(hub);
/* write registers */
for (i = 0; i < (USB251XB_I2C_REG_SZ / USB251XB_I2C_WRITE_SZ); i++) {