[SCSI] lpfc 8.3.18: Add logic to detect last devloss timeout
Added driver logic to detect the last devloss timeout of remote nodes which
was still in use of FCF. At that point, the driver should set the last
in-use remote node devloss timeout flag if it was not already set and should
perform proper action on the in-use FCF and recover of FCF from firmware,
depending on the state the driver's FIP engine is in.
Find eligible FCF through FCF table rescan or the next new FCF event when
FCF table rescan turned out empty eligible FCF, and the successful flogi
into an FCF shall clear the HBA_DEVLOSS_TMO flag, indicating the successful
recovery from devloss timeout.
[jejb: add delay.h include to lpfc_hbadisc.c to fix ppc compile]
Signed-off-by: Alex Iannicelli <alex.iannicelli@emulex.com>
Signed-off-by: James Smart <james.smart@emulex.com>
Signed-off-by: James Bottomley <James.Bottomley@suse.de>
diff --git a/drivers/scsi/lpfc/lpfc_sli4.h b/drivers/scsi/lpfc/lpfc_sli4.h
index a0ca572..98da223 100644
--- a/drivers/scsi/lpfc/lpfc_sli4.h
+++ b/drivers/scsi/lpfc/lpfc_sli4.h
@@ -23,6 +23,9 @@
#define LPFC_GET_QE_REL_INT 32
#define LPFC_RPI_LOW_WATER_MARK 10
+#define LPFC_UNREG_FCF 1
+#define LPFC_SKIP_UNREG_FCF 0
+
/* Amount of time in seconds for waiting FCF rediscovery to complete */
#define LPFC_FCF_REDISCOVER_WAIT_TMO 2000 /* msec */
@@ -163,9 +166,8 @@
#define FCF_REDISC_PEND 0x80 /* FCF rediscovery pending */
#define FCF_REDISC_EVT 0x100 /* FCF rediscovery event to worker thread */
#define FCF_REDISC_FOV 0x200 /* Post FCF rediscovery fast failover */
-#define FCF_REDISC_RRU 0x400 /* Roundrobin bitmap updated */
+#define FCF_REDISC_PROG (FCF_REDISC_PEND | FCF_REDISC_EVT)
uint32_t addr_mode;
- uint16_t fcf_rr_init_indx;
uint32_t eligible_fcf_cnt;
struct lpfc_fcf_rec current_rec;
struct lpfc_fcf_rec failover_rec;