drm/i915: don't apply Display WAs 1125 and 1126 to GLK/CNL+
BSpec does not show these WAs as applicable to GLK, and for CNL it
only shows them applicable for a super early pre-production stepping
we shouldn't be caring about anymore. Remove these so we can avoid
them on ICL too.
v2: Change how we check for gen9 display platforms (Ville).
Cc: Matt Roper <matthew.d.roper@intel.com>
Reviewed-by: Ville Syrjälä <ville.syrjala@linux.intel.com>
Signed-off-by: Paulo Zanoni <paulo.r.zanoni@intel.com>
Signed-off-by: Ville Syrjälä <ville.syrjala@linux.intel.com>
Link: https://patchwork.freedesktop.org/patch/msgid/20181114012432.21809-1-paulo.r.zanoni@intel.com
diff --git a/drivers/gpu/drm/i915/intel_pm.c b/drivers/gpu/drm/i915/intel_pm.c
index b11fac6..2a6ffb8 100644
--- a/drivers/gpu/drm/i915/intel_pm.c
+++ b/drivers/gpu/drm/i915/intel_pm.c
@@ -4730,28 +4730,31 @@ static void skl_compute_plane_wm(const struct intel_crtc_state *cstate,
res_lines = div_round_up_fixed16(selected_result,
wp->plane_blocks_per_line);
- /* Display WA #1125: skl,bxt,kbl,glk */
- if (level == 0 && wp->rc_surface)
- res_blocks += fixed16_to_u32_round_up(wp->y_tile_minimum);
+ if (IS_GEN9_BC(dev_priv) || IS_BROXTON(dev_priv)) {
+ /* Display WA #1125: skl,bxt,kbl */
+ if (level == 0 && wp->rc_surface)
+ res_blocks +=
+ fixed16_to_u32_round_up(wp->y_tile_minimum);
- /* Display WA #1126: skl,bxt,kbl,glk */
- if (level >= 1 && level <= 7) {
- if (wp->y_tiled) {
- res_blocks += fixed16_to_u32_round_up(
- wp->y_tile_minimum);
- res_lines += wp->y_min_scanlines;
- } else {
- res_blocks++;
+ /* Display WA #1126: skl,bxt,kbl */
+ if (level >= 1 && level <= 7) {
+ if (wp->y_tiled) {
+ res_blocks +=
+ fixed16_to_u32_round_up(wp->y_tile_minimum);
+ res_lines += wp->y_min_scanlines;
+ } else {
+ res_blocks++;
+ }
+
+ /*
+ * Make sure result blocks for higher latency levels are
+ * atleast as high as level below the current level.
+ * Assumption in DDB algorithm optimization for special
+ * cases. Also covers Display WA #1125 for RC.
+ */
+ if (result_prev->plane_res_b > res_blocks)
+ res_blocks = result_prev->plane_res_b;
}
-
- /*
- * Make sure result blocks for higher latency levels are atleast
- * as high as level below the current level.
- * Assumption in DDB algorithm optimization for special cases.
- * Also covers Display WA #1125 for RC.
- */
- if (result_prev->plane_res_b > res_blocks)
- res_blocks = result_prev->plane_res_b;
}
/* The number of lines are ignored for the level 0 watermark. */