cpufreq: AMD "frequency sensitivity feedback" powersave bias for ondemand governor
Future AMD processors, starting with Family 16h, can provide software
with feedback on how the workload may respond to frequency change --
memory-bound workloads will not benefit from higher frequency, where
as compute-bound workloads will. This patch enables this "frequency
sensitivity feedback" to aid the ondemand governor to make better
frequency change decisions by hooking into the powersave bias.
Signed-off-by: Jacob Shin <jacob.shin@amd.com>
Acked-by: Thomas Renninger <trenn@suse.de>
Acked-by: Borislav Petkov <bp@suse.de>
Acked-by: Viresh Kumar <viresh.kumar@linaro.org>
Signed-off-by: Rafael J. Wysocki <rafael.j.wysocki@intel.com>
diff --git a/Documentation/cpu-freq/governors.txt b/Documentation/cpu-freq/governors.txt
index 4dfed30..66f9cc3 100644
--- a/Documentation/cpu-freq/governors.txt
+++ b/Documentation/cpu-freq/governors.txt
@@ -167,6 +167,27 @@
busy, rather than shifting back and forth in speed. This tunable has no
effect on behavior at lower speeds/lower CPU loads.
+powersave_bias: this parameter takes a value between 0 to 1000. It
+defines the percentage (times 10) value of the target frequency that
+will be shaved off of the target. For example, when set to 100 -- 10%,
+when ondemand governor would have targeted 1000 MHz, it will target
+1000 MHz - (10% of 1000 MHz) = 900 MHz instead. This is set to 0
+(disabled) by default.
+When AMD frequency sensitivity powersave bias driver --
+drivers/cpufreq/amd_freq_sensitivity.c is loaded, this parameter
+defines the workload frequency sensitivity threshold in which a lower
+frequency is chosen instead of ondemand governor's original target.
+The frequency sensitivity is a hardware reported (on AMD Family 16h
+Processors and above) value between 0 to 100% that tells software how
+the performance of the workload running on a CPU will change when
+frequency changes. A workload with sensitivity of 0% (memory/IO-bound)
+will not perform any better on higher core frequency, whereas a
+workload with sensitivity of 100% (CPU-bound) will perform better
+higher the frequency. When the driver is loaded, this is set to 400
+by default -- for CPUs running workloads with sensitivity value below
+40%, a lower frequency is chosen. Unloading the driver or writing 0
+will disable this feature.
+
2.5 Conservative
----------------