drm/i915: Let panel power sequencing hardware do its job
The panel power sequencing hardware tracks the stages of panel power
sequencing and signals when the panel is completely on or off. Instead
of blindly assuming the panel timings will work, poll the panel power
status register until it shows the correct values.
Signed-off-by: Keith Packard <keithp@keithp.com>
Reviewed-by: Jesse Barnes <jbarnes@virtuousgeek.org>
diff --git a/drivers/gpu/drm/i915/i915_reg.h b/drivers/gpu/drm/i915/i915_reg.h
index a34e866..b080cc8 100644
--- a/drivers/gpu/drm/i915/i915_reg.h
+++ b/drivers/gpu/drm/i915/i915_reg.h
@@ -1553,12 +1553,21 @@
*/
#define PP_READY (1 << 30)
#define PP_SEQUENCE_NONE (0 << 28)
-#define PP_SEQUENCE_ON (1 << 28)
-#define PP_SEQUENCE_OFF (2 << 28)
-#define PP_SEQUENCE_MASK 0x30000000
+#define PP_SEQUENCE_POWER_UP (1 << 28)
+#define PP_SEQUENCE_POWER_DOWN (2 << 28)
+#define PP_SEQUENCE_MASK (3 << 28)
+#define PP_SEQUENCE_SHIFT 28
#define PP_CYCLE_DELAY_ACTIVE (1 << 27)
-#define PP_SEQUENCE_STATE_ON_IDLE (1 << 3)
#define PP_SEQUENCE_STATE_MASK 0x0000000f
+#define PP_SEQUENCE_STATE_OFF_IDLE (0x0 << 0)
+#define PP_SEQUENCE_STATE_OFF_S0_1 (0x1 << 0)
+#define PP_SEQUENCE_STATE_OFF_S0_2 (0x2 << 0)
+#define PP_SEQUENCE_STATE_OFF_S0_3 (0x3 << 0)
+#define PP_SEQUENCE_STATE_ON_IDLE (0x8 << 0)
+#define PP_SEQUENCE_STATE_ON_S1_0 (0x9 << 0)
+#define PP_SEQUENCE_STATE_ON_S1_2 (0xa << 0)
+#define PP_SEQUENCE_STATE_ON_S1_3 (0xb << 0)
+#define PP_SEQUENCE_STATE_RESET (0xf << 0)
#define PP_CONTROL 0x61204
#define POWER_TARGET_ON (1 << 0)
#define PP_ON_DELAYS 0x61208