ath10k: add support for HTT 3.0
New firmware comes with new HTT protocol version.
In 3.0 the separate mgmt tx command has been
removed. All traffic is to be pushed through data
tx (tx_frm) command with a twist - FW seems to not
be able (yet?) to access tx fragment table so for
manamgement frames frame pointer is passed
directly.
Signed-off-by: Michal Kazior <michal.kazior@tieto.com>
Signed-off-by: Kalle Valo <kvalo@qca.qualcomm.com>
diff --git a/drivers/net/wireless/ath/ath10k/mac.c b/drivers/net/wireless/ath/ath10k/mac.c
index 7eab8a4..248248b 100644
--- a/drivers/net/wireless/ath/ath10k/mac.c
+++ b/drivers/net/wireless/ath/ath10k/mac.c
@@ -1473,6 +1473,12 @@
struct ieee80211_hdr *hdr = (struct ieee80211_hdr *)skb->data;
int ret;
+ if (ar->htt.target_version_major >= 3) {
+ /* Since HTT 3.0 there is no separate mgmt tx command */
+ ret = ath10k_htt_tx(&ar->htt, skb);
+ goto exit;
+ }
+
if (ieee80211_is_mgmt(hdr->frame_control))
ret = ath10k_htt_mgmt_tx(&ar->htt, skb);
else if (ieee80211_is_nullfunc(hdr->frame_control))
@@ -1484,6 +1490,7 @@
else
ret = ath10k_htt_tx(&ar->htt, skb);
+exit:
if (ret) {
ath10k_warn("tx failed (%d). dropping packet.\n", ret);
ieee80211_free_txskb(ar->hw, skb);
@@ -1720,8 +1727,10 @@
/* we must calculate tid before we apply qos workaround
* as we'd lose the qos control field */
tid = HTT_DATA_TX_EXT_TID_NON_QOS_MCAST_BCAST;
- if (ieee80211_is_data_qos(hdr->frame_control) &&
- is_unicast_ether_addr(ieee80211_get_DA(hdr))) {
+ if (ieee80211_is_mgmt(hdr->frame_control)) {
+ tid = HTT_DATA_TX_EXT_TID_MGMT;
+ } else if (ieee80211_is_data_qos(hdr->frame_control) &&
+ is_unicast_ether_addr(ieee80211_get_DA(hdr))) {
u8 *qc = ieee80211_get_qos_ctl(hdr);
tid = qc[0] & IEEE80211_QOS_CTL_TID_MASK;
}