be2net: Remove useless DMA-32 fallback configuration
As stated in [1], dma_set_mask() with a 64-bit mask never fails if
dev->dma_mask is non-NULL.
So, if it fails, the 32 bits case will also fail for the same reason.
So if dma_set_mask_and_coherent() succeeds, 'netdev->features' will have
NETIF_F_HIGHDMA in all cases. Move the assignment of this feature in
be_netdev_init() instead be_probe() which is a much logical place.
Simplify code and remove some dead code accordingly.
[1]: https://lkml.org/lkml/2021/6/7/398
Signed-off-by: Christophe JAILLET <christophe.jaillet@wanadoo.fr>
Link: https://lore.kernel.org/r/637696d7141faa68c29fc34b70f9aa67d5e605f0.1641718999.git.christophe.jaillet@wanadoo.fr
Signed-off-by: Jakub Kicinski <kuba@kernel.org>
diff --git a/drivers/net/ethernet/emulex/benet/be_main.c b/drivers/net/ethernet/emulex/benet/be_main.c
index d51f24c..ad67b42 100644
--- a/drivers/net/ethernet/emulex/benet/be_main.c
+++ b/drivers/net/ethernet/emulex/benet/be_main.c
@@ -5194,7 +5194,8 @@ static void be_netdev_init(struct net_device *netdev)
netdev->hw_features |= NETIF_F_RXHASH;
netdev->features |= netdev->hw_features |
- NETIF_F_HW_VLAN_CTAG_RX | NETIF_F_HW_VLAN_CTAG_FILTER;
+ NETIF_F_HW_VLAN_CTAG_RX | NETIF_F_HW_VLAN_CTAG_FILTER |
+ NETIF_F_HIGHDMA;
netdev->vlan_features |= NETIF_F_SG | NETIF_F_TSO | NETIF_F_TSO6 |
NETIF_F_IP_CSUM | NETIF_F_IPV6_CSUM;
@@ -5840,14 +5841,9 @@ static int be_probe(struct pci_dev *pdev, const struct pci_device_id *pdev_id)
SET_NETDEV_DEV(netdev, &pdev->dev);
status = dma_set_mask_and_coherent(&pdev->dev, DMA_BIT_MASK(64));
- if (!status) {
- netdev->features |= NETIF_F_HIGHDMA;
- } else {
- status = dma_set_mask_and_coherent(&pdev->dev, DMA_BIT_MASK(32));
- if (status) {
- dev_err(&pdev->dev, "Could not set PCI DMA Mask\n");
- goto free_netdev;
- }
+ if (status) {
+ dev_err(&pdev->dev, "Could not set PCI DMA Mask\n");
+ goto free_netdev;
}
status = pci_enable_pcie_error_reporting(pdev);