scsi: lpfc: Fix crash due to port reset racing vs adapter error handling
If the adapter encounters a condition which causes the adapter to fail
(driver must detect the failure) simultaneously to a request to the driver
to reset the adapter (such as a host_reset), the reset path will be racing
with the asynchronously-detect adapter failure path. In the failing
situation, one path has started to tear down the adapter data structures
(io_wq's) while the other path has initiated a repeat of the teardown and
is in the lpfc_sli_flush_xxx_rings path and attempting to access the
just-freed data structures.
Fix by the following:
- In cases where an adapter failure is detected, rather than explicitly
calling offline_eratt() to start the teardown, change the adapter state
and let the later calls of posted work to the slowpath thread invoke the
adapter recovery. In essence, this means all requests to reset are
serialized on the slowpath thread.
- Clean up the routine that restarts the adapter. If there is a failure
from brdreset, don't immediately error and leave things in a partial
state. Instead, ensure the adapter state is set and finish the teardown
of structures before returning.
- If in the scsi host reset handler and the board fails to reset and
restart (which can be due to parallel reset/recovery paths), instead of
hard failing and explicitly calling offline_eratt() (which gets into the
redundant path), just fail out and let the asynchronous path resolve the
adapter state.
Signed-off-by: Dick Kennedy <dick.kennedy@broadcom.com>
Signed-off-by: James Smart <jsmart2021@gmail.com>
Signed-off-by: Martin K. Petersen <martin.petersen@oracle.com>
diff --git a/drivers/scsi/lpfc/lpfc_init.c b/drivers/scsi/lpfc/lpfc_init.c
index 8429de6..c549212 100644
--- a/drivers/scsi/lpfc/lpfc_init.c
+++ b/drivers/scsi/lpfc/lpfc_init.c
@@ -1926,7 +1926,7 @@ lpfc_handle_eratt_s4(struct lpfc_hba *phba)
lpfc_printf_log(phba, KERN_ERR, LOG_INIT,
"7624 Firmware not ready: Failing UE recovery,"
" waited %dSec", i);
- lpfc_sli4_offline_eratt(phba);
+ phba->link_state = LPFC_HBA_ERROR;
break;
case LPFC_SLI_INTF_IF_TYPE_2:
@@ -2000,9 +2000,8 @@ lpfc_handle_eratt_s4(struct lpfc_hba *phba)
}
/* fall through for not able to recover */
lpfc_printf_log(phba, KERN_ERR, LOG_INIT,
- "3152 Unrecoverable error, bring the port "
- "offline\n");
- lpfc_sli4_offline_eratt(phba);
+ "3152 Unrecoverable error\n");
+ phba->link_state = LPFC_HBA_ERROR;
break;
case LPFC_SLI_INTF_IF_TYPE_1:
default: