ACPI / PM: Use ACPI_STATE_D3_COLD instead of ACPI_STATE_D3 everywhere
There are several places in the tree where ACPI_STATE_D3 is used
instead of ACPI_STATE_D3_COLD which should be used instead for
clarity. Modify them all to use ACPI_STATE_D3_COLD as appropriate.
[The definition of ACPI_STATE_D3 itself cannot go away at this point
as it is part of ACPICA.]
Signed-off-by: Rafael J. Wysocki <rafael.j.wysocki@intel.com>
Reviewed-by: Aaron Lu <aaron.lu@intel.com>
diff --git a/drivers/ata/libata-acpi.c b/drivers/ata/libata-acpi.c
index cf4e702..da8170d 100644
--- a/drivers/ata/libata-acpi.c
+++ b/drivers/ata/libata-acpi.c
@@ -947,11 +947,11 @@
continue;
acpi_bus_set_power(dev_handle, state.event & PM_EVENT_RESUME ?
- ACPI_STATE_D0 : ACPI_STATE_D3);
+ ACPI_STATE_D0 : ACPI_STATE_D3_COLD);
}
if (!(state.event & PM_EVENT_RESUME))
- acpi_bus_set_power(port_handle, ACPI_STATE_D3);
+ acpi_bus_set_power(port_handle, ACPI_STATE_D3_COLD);
}
/**