e1000e: 82579 performance improvements
The initial support for 82579 was tuned poorly for performance. Adjust the
packet buffer allocation appropriately for both standard and jumbo frames;
and for jumbo frames increase the receive descriptor pre-fetch, disable
adaptive interrupt moderation and set the DMA latency tolerance.
Signed-off-by: Bruce Allan <bruce.w.allan@intel.com>
Tested-by: Jeff Pieper <jeffrey.e.pieper@intel.com>
Signed-off-by: Jeff Kirsher <jeffrey.t.kirsher@intel.com>
Signed-off-by: David S. Miller <davem@davemloft.net>
diff --git a/drivers/net/e1000e/netdev.c b/drivers/net/e1000e/netdev.c
index 1aa4228..992b622 100644
--- a/drivers/net/e1000e/netdev.c
+++ b/drivers/net/e1000e/netdev.c
@@ -2290,6 +2290,11 @@
goto set_itr_now;
}
+ if (adapter->flags2 & FLAG2_DISABLE_AIM) {
+ new_itr = 0;
+ goto set_itr_now;
+ }
+
adapter->tx_itr = e1000_update_itr(adapter,
adapter->tx_itr,
adapter->total_tx_packets,
@@ -2338,7 +2343,10 @@
if (adapter->msix_entries)
adapter->rx_ring->set_itr = 1;
else
- ew32(ITR, 1000000000 / (new_itr * 256));
+ if (new_itr)
+ ew32(ITR, 1000000000 / (new_itr * 256));
+ else
+ ew32(ITR, 0);
}
}
@@ -2920,7 +2928,7 @@
/* irq moderation */
ew32(RADV, adapter->rx_abs_int_delay);
- if (adapter->itr_setting != 0)
+ if ((adapter->itr_setting != 0) && (adapter->itr != 0))
ew32(ITR, 1000000000 / (adapter->itr * 256));
ctrl_ext = er32(CTRL_EXT);
@@ -2965,11 +2973,13 @@
* packet size is equal or larger than the specified value (in 8 byte
* units), e.g. using jumbo frames when setting to E1000_ERT_2048
*/
- if (adapter->flags & FLAG_HAS_ERT) {
+ if ((adapter->flags & FLAG_HAS_ERT) ||
+ (adapter->hw.mac.type == e1000_pch2lan)) {
if (adapter->netdev->mtu > ETH_DATA_LEN) {
u32 rxdctl = er32(RXDCTL(0));
ew32(RXDCTL(0), rxdctl | 0x3);
- ew32(ERT, E1000_ERT_2048 | (1 << 13));
+ if (adapter->flags & FLAG_HAS_ERT)
+ ew32(ERT, E1000_ERT_2048 | (1 << 13));
/*
* With jumbo frames and early-receive enabled,
* excessive C-state transition latencies result in
@@ -3232,9 +3242,35 @@
fc->low_water = 0x05048;
fc->pause_time = 0x0650;
fc->refresh_time = 0x0400;
+ if (adapter->netdev->mtu > ETH_DATA_LEN) {
+ pba = 14;
+ ew32(PBA, pba);
+ }
break;
}
+ /*
+ * Disable Adaptive Interrupt Moderation if 2 full packets cannot
+ * fit in receive buffer and early-receive not supported.
+ */
+ if (adapter->itr_setting & 0x3) {
+ if (((adapter->max_frame_size * 2) > (pba << 10)) &&
+ !(adapter->flags & FLAG_HAS_ERT)) {
+ if (!(adapter->flags2 & FLAG2_DISABLE_AIM)) {
+ dev_info(&adapter->pdev->dev,
+ "Interrupt Throttle Rate turned off\n");
+ adapter->flags2 |= FLAG2_DISABLE_AIM;
+ ew32(ITR, 0);
+ }
+ } else if (adapter->flags2 & FLAG2_DISABLE_AIM) {
+ dev_info(&adapter->pdev->dev,
+ "Interrupt Throttle Rate turned on\n");
+ adapter->flags2 &= ~FLAG2_DISABLE_AIM;
+ adapter->itr = 20000;
+ ew32(ITR, 1000000000 / (adapter->itr * 256));
+ }
+ }
+
/* Allow time for pending master requests to run */
mac->ops.reset_hw(hw);
@@ -3553,7 +3589,8 @@
e1000_update_mng_vlan(adapter);
/* DMA latency requirement to workaround early-receive/jumbo issue */
- if (adapter->flags & FLAG_HAS_ERT)
+ if ((adapter->flags & FLAG_HAS_ERT) ||
+ (adapter->hw.mac.type == e1000_pch2lan))
pm_qos_add_request(&adapter->netdev->pm_qos_req,
PM_QOS_CPU_DMA_LATENCY,
PM_QOS_DEFAULT_VALUE);
@@ -3662,7 +3699,8 @@
if (adapter->flags & FLAG_HAS_AMT)
e1000_release_hw_control(adapter);
- if (adapter->flags & FLAG_HAS_ERT)
+ if ((adapter->flags & FLAG_HAS_ERT) ||
+ (adapter->hw.mac.type == e1000_pch2lan))
pm_qos_remove_request(&adapter->netdev->pm_qos_req);
pm_runtime_put_sync(&pdev->dev);