rcu: Convert CONFIG_RCU_FANOUT_EXACT to boot parameter
The CONFIG_RCU_FANOUT_EXACT Kconfig parameter is used primarily (and
perhaps only) by rcutorture to verify that RCU works correctly in specific
rcu_node combining-tree configurations. It therefore does not make
much sense have this as a question to people attempting to configure
their kernels. So this commit creates an rcutree.rcu_fanout_exact=
boot parameter that rcutorture can use, and eliminates the original
CONFIG_RCU_FANOUT_EXACT Kconfig parameter.
Reported-by: Ingo Molnar <mingo@kernel.org>
Signed-off-by: Paul E. McKenney <paulmck@linux.vnet.ibm.com>
Reviewed-by: Pranith Kumar <bobby.prani@gmail.com>
diff --git a/kernel/rcu/tree.c b/kernel/rcu/tree.c
index 2f3cb55..b49c474 100644
--- a/kernel/rcu/tree.c
+++ b/kernel/rcu/tree.c
@@ -113,6 +113,9 @@
static struct rcu_state *rcu_state_p;
LIST_HEAD(rcu_struct_flavors);
+/* Control rcu_node-tree auto-balancing at boot time. */
+static bool rcu_fanout_exact;
+module_param(rcu_fanout_exact, bool, 0444);
/* Increase (but not decrease) the CONFIG_RCU_FANOUT_LEAF at boot time. */
static int rcu_fanout_leaf = CONFIG_RCU_FANOUT_LEAF;
module_param(rcu_fanout_leaf, int, 0444);
@@ -3956,13 +3959,13 @@
/*
* Compute the per-level fanout, either using the exact fanout specified
- * or balancing the tree, depending on CONFIG_RCU_FANOUT_EXACT.
+ * or balancing the tree, depending on the rcu_fanout_exact boot parameter.
*/
static void __init rcu_init_levelspread(struct rcu_state *rsp)
{
int i;
- if (IS_ENABLED(CONFIG_RCU_FANOUT_EXACT)) {
+ if (rcu_fanout_exact) {
rsp->levelspread[rcu_num_lvls - 1] = rcu_fanout_leaf;
for (i = rcu_num_lvls - 2; i >= 0; i--)
rsp->levelspread[i] = CONFIG_RCU_FANOUT;