net: dsa: mv88e6xxx: Flood all traffic classes on standalone ports
In accordance with the comment in dsa_port_bridge_leave, standalone
ports shall be configured to flood all types of traffic. This change
aligns the mv88e6xxx driver with that policy.
Previously a standalone port would initially not egress any unknown
traffic, but after joining and then leaving a bridge, it would.
This does not matter that much since we only ever send FROM_CPUs on
standalone ports, but it seems prudent to make sure that the initial
values match those that are applied after a bridging/unbridging cycle.
Signed-off-by: Tobias Waldekranz <tobias@waldekranz.com>
Reviewed-by: Vladimir Oltean <olteanv@gmail.com>
Reviewed-by: Florian Fainelli <f.fainelli@gmail.com>
Reviewed-by: Andrew Lunn <andrew@lunn.ch>
Signed-off-by: David S. Miller <davem@davemloft.net>
diff --git a/drivers/net/dsa/mv88e6xxx/chip.c b/drivers/net/dsa/mv88e6xxx/chip.c
index 17578f7..587959b 100644
--- a/drivers/net/dsa/mv88e6xxx/chip.c
+++ b/drivers/net/dsa/mv88e6xxx/chip.c
@@ -2489,19 +2489,15 @@ static int mv88e6xxx_setup_message_port(struct mv88e6xxx_chip *chip, int port)
static int mv88e6xxx_setup_egress_floods(struct mv88e6xxx_chip *chip, int port)
{
- struct dsa_switch *ds = chip->ds;
- bool flood;
int err;
- /* Upstream ports flood frames with unknown unicast or multicast DA */
- flood = dsa_is_cpu_port(ds, port) || dsa_is_dsa_port(ds, port);
if (chip->info->ops->port_set_ucast_flood) {
- err = chip->info->ops->port_set_ucast_flood(chip, port, flood);
+ err = chip->info->ops->port_set_ucast_flood(chip, port, true);
if (err)
return err;
}
if (chip->info->ops->port_set_mcast_flood) {
- err = chip->info->ops->port_set_mcast_flood(chip, port, flood);
+ err = chip->info->ops->port_set_mcast_flood(chip, port, true);
if (err)
return err;
}