ibmvnic: Only do H_EOI for mobility events
When enabling the sub-CRQ IRQ a previous update sent a H_EOI prior
to the enablement to clear any pending interrupts that may be present
across a partition migration. This fixed a firmware bug where a
migration could erroneously indicate that a H_EOI was pending.
The H_EOI should only be sent when enabling during a mobility
event though. Doing so at other time could wrong and can produce
extra driver output when IRQs are enabled when doing TX completion.
Signed-off-by: Nathan Fontenot <nfont@linux.vnet.ibm.com>
Signed-off-by: David S. Miller <davem@davemloft.net>
diff --git a/drivers/net/ethernet/ibm/ibmvnic.c b/drivers/net/ethernet/ibm/ibmvnic.c
index 4bb4646..62cd360 100644
--- a/drivers/net/ethernet/ibm/ibmvnic.c
+++ b/drivers/net/ethernet/ibm/ibmvnic.c
@@ -2617,18 +2617,21 @@ static int enable_scrq_irq(struct ibmvnic_adapter *adapter,
{
struct device *dev = &adapter->vdev->dev;
unsigned long rc;
- u64 val;
if (scrq->hw_irq > 0x100000000ULL) {
dev_err(dev, "bad hw_irq = %lx\n", scrq->hw_irq);
return 1;
}
- val = (0xff000000) | scrq->hw_irq;
- rc = plpar_hcall_norets(H_EOI, val);
- if (rc)
- dev_err(dev, "H_EOI FAILED irq 0x%llx. rc=%ld\n",
- val, rc);
+ if (adapter->resetting &&
+ adapter->reset_reason == VNIC_RESET_MOBILITY) {
+ u64 val = (0xff000000) | scrq->hw_irq;
+
+ rc = plpar_hcall_norets(H_EOI, val);
+ if (rc)
+ dev_err(dev, "H_EOI FAILED irq 0x%llx. rc=%ld\n",
+ val, rc);
+ }
rc = plpar_hcall_norets(H_VIOCTL, adapter->vdev->unit_address,
H_ENABLE_VIO_INTERRUPT, scrq->hw_irq, 0, 0);