ata: Fix ZBC_OUT all bit handling
If the ALL bit is set in the ZBC_OUT command, the command zone ID field
(block) should be ignored.
Reported-by: David Butterfield <david.butterfield@wdc.com>
Signed-off-by: Damien Le Moal <damien.lemoal@wdc.com>
Cc: stable@vger.kernel.org
Signed-off-by: Tejun Heo <tj@kernel.org>
diff --git a/drivers/ata/libata-scsi.c b/drivers/ata/libata-scsi.c
index a554375..aad1b01 100644
--- a/drivers/ata/libata-scsi.c
+++ b/drivers/ata/libata-scsi.c
@@ -3805,7 +3805,14 @@ static unsigned int ata_scsi_zbc_out_xlat(struct ata_queued_cmd *qc)
*/
goto invalid_param_len;
}
- if (block >= dev->n_sectors) {
+
+ all = cdb[14] & 0x1;
+ if (all) {
+ /*
+ * Ignore the block address (zone ID) as defined by ZBC.
+ */
+ block = 0;
+ } else if (block >= dev->n_sectors) {
/*
* Block must be a valid zone ID (a zone start LBA).
*/
@@ -3813,8 +3820,6 @@ static unsigned int ata_scsi_zbc_out_xlat(struct ata_queued_cmd *qc)
goto invalid_fld;
}
- all = cdb[14] & 0x1;
-
if (ata_ncq_enabled(qc->dev) &&
ata_fpdma_zac_mgmt_out_supported(qc->dev)) {
tf->protocol = ATA_PROT_NCQ_NODATA;