arm64: KVM: add SGI generation register emulation
While the generation of a (virtual) inter-processor interrupt (SGI)
on a GICv2 works by writing to a MMIO register, GICv3 uses the system
register ICC_SGI1R_EL1 to trigger them.
Add a trap handler function that calls the new SGI register handler
in the GICv3 code. As ICC_SRE_EL1.SRE at this point is still always 0,
this will not trap yet, but will only be used later when all the data
structures have been initialized properly.
Signed-off-by: Andre Przywara <andre.przywara@arm.com>
Reviewed-by: Christoffer Dall <christoffer.dall@linaro.org>
Signed-off-by: Christoffer Dall <christoffer.dall@linaro.org>
diff --git a/include/kvm/arm_vgic.h b/include/kvm/arm_vgic.h
index 98c3016..b9b2e05 100644
--- a/include/kvm/arm_vgic.h
+++ b/include/kvm/arm_vgic.h
@@ -307,6 +307,7 @@
void kvm_vgic_sync_hwstate(struct kvm_vcpu *vcpu);
int kvm_vgic_inject_irq(struct kvm *kvm, int cpuid, unsigned int irq_num,
bool level);
+void vgic_v3_dispatch_sgi(struct kvm_vcpu *vcpu, u64 reg);
int kvm_vgic_vcpu_pending_irq(struct kvm_vcpu *vcpu);
bool vgic_handle_mmio(struct kvm_vcpu *vcpu, struct kvm_run *run,
struct kvm_exit_mmio *mmio);