dsa: Move gpio reset into switch driver
Resetting the switch is something the driver does, not the framework.
So move the parsing of this property into the driver.
There are no in kernel users of this property, so moving it does not
break anything. There is however a board which will make use of this
property making its way into the kernel.
Signed-off-by: Andrew Lunn <andrew@lunn.ch>
Signed-off-by: David S. Miller <davem@davemloft.net>
diff --git a/Documentation/devicetree/bindings/net/dsa/marvell.txt b/Documentation/devicetree/bindings/net/dsa/marvell.txt
index cdd70ce..7629189 100644
--- a/Documentation/devicetree/bindings/net/dsa/marvell.txt
+++ b/Documentation/devicetree/bindings/net/dsa/marvell.txt
@@ -10,10 +10,17 @@
Marvell Switches are MDIO devices. The following properties should be
placed as a child node of an mdio device.
+The properties described here are those specific to Marvell devices.
+Additional required and optional properties can be found in dsa.txt.
+
Required properties:
- compatible : Should be one of "marvell,mv88e6085",
- reg : Address on the MII bus for the switch.
+Optional properties:
+
+- reset-gpios : Should be a gpio specifier for a reset line
+
Example:
mdio {
@@ -23,5 +30,6 @@
switch0: switch@0 {
compatible = "marvell,mv88e6085";
reg = <0>;
+ reset-gpios = <&gpio5 1 GPIO_ACTIVE_LOW>;
};
};