xHCI: Clear PLC in xhci_bus_resume()
This patch clears PORT_PLC if xhci_bus_resume() resumes a previous suspended
port, because if a port transition from U3 to U0 state, it will report a
port link state change, and software should clear the corresponding PLC bit.
It also uses hcd->speed to check if a port is a USB2 protocol port.
The patch fixes the issue that USB keyboard can not wakeup system from
hibernation.
Signed-off-by: Andiry Xu <andiry.xu@amd.com>
Signed-off-by: Sarah Sharp <sarah.a.sharp@linux.intel.com>
diff --git a/drivers/usb/host/xhci-hub.c b/drivers/usb/host/xhci-hub.c
index a78f2eb..73f75d2 100644
--- a/drivers/usb/host/xhci-hub.c
+++ b/drivers/usb/host/xhci-hub.c
@@ -777,7 +777,7 @@
if (t1 != t2)
xhci_writel(xhci, t2, port_array[port_index]);
- if (DEV_HIGHSPEED(t1)) {
+ if (hcd->speed != HCD_USB3) {
/* enable remote wake up for USB 2.0 */
u32 __iomem *addr;
u32 tmp;
@@ -866,6 +866,21 @@
temp |= PORT_LINK_STROBE | XDEV_U0;
xhci_writel(xhci, temp, port_array[port_index]);
}
+ /* wait for the port to enter U0 and report port link
+ * state change.
+ */
+ spin_unlock_irqrestore(&xhci->lock, flags);
+ msleep(20);
+ spin_lock_irqsave(&xhci->lock, flags);
+
+ /* Clear PLC */
+ temp = xhci_readl(xhci, port_array[port_index]);
+ if (temp & PORT_PLC) {
+ temp = xhci_port_state_to_neutral(temp);
+ temp |= PORT_PLC;
+ xhci_writel(xhci, temp, port_array[port_index]);
+ }
+
slot_id = xhci_find_slot_id_by_port(hcd,
xhci, port_index + 1);
if (slot_id)
@@ -873,7 +888,7 @@
} else
xhci_writel(xhci, temp, port_array[port_index]);
- if (DEV_HIGHSPEED(temp)) {
+ if (hcd->speed != HCD_USB3) {
/* disable remote wake up for USB 2.0 */
u32 __iomem *addr;
u32 tmp;