md/raid5: use md_write_start to count stripes, not bios
We use md_write_start() to increase the count of pending writes, and
md_write_end() to decrement the count. We currently count bios
submitted to md/raid5. Change it count stripe_heads that a WRITE bio
has been attached to.
So now, raid5_make_request() calls md_write_start() and then
md_write_end() to keep the count elevated during the setup of the
request.
add_stripe_bio() calls md_write_start() for each stripe_head, and the
completion routines always call md_write_end(), instead of only
calling it when raid5_dec_bi_active_stripes() returns 0.
make_discard_request also calls md_write_start/end().
The parallel between md_write_{start,end} and use of bi_phys_segments
can be seen in that:
Whenever we set bi_phys_segments to 1, we now call md_write_start.
Whenever we increment it on non-read requests with
raid5_inc_bi_active_stripes(), we now call md_write_start().
Whenever we decrement bi_phys_segments on non-read requsts with
raid5_dec_bi_active_stripes(), we now call md_write_end().
This reduces our dependence on keeping a per-bio count of active
stripes in bi_phys_segments.
md_write_inc() is added which parallels md_write_start(), but requires
that a write has already been started, and is certain never to sleep.
This can be used inside a spinlocked region when adding to a write
request.
Signed-off-by: NeilBrown <neilb@suse.com>
Signed-off-by: Shaohua Li <shli@fb.com>
diff --git a/drivers/md/md.h b/drivers/md/md.h
index e094006..0cd1272 100644
--- a/drivers/md/md.h
+++ b/drivers/md/md.h
@@ -648,6 +648,7 @@ extern void md_wakeup_thread(struct md_thread *thread);
extern void md_check_recovery(struct mddev *mddev);
extern void md_reap_sync_thread(struct mddev *mddev);
extern void md_write_start(struct mddev *mddev, struct bio *bi);
+extern void md_write_inc(struct mddev *mddev, struct bio *bi);
extern void md_write_end(struct mddev *mddev);
extern void md_done_sync(struct mddev *mddev, int blocks, int ok);
extern void md_error(struct mddev *mddev, struct md_rdev *rdev);