tree dd8be0f01d94130ad82ea54e3dd6b51808c796e8
parent 907d139318b5109e5b676b32b0f4a2c666a8d9ac
author Michael Roth <michael.roth@amd.com> 1639674834 -0600
committer Paolo Bonzini <pbonzini@redhat.com> 1641570286 -0500

KVM: SVM: include CR3 in initial VMSA state for SEV-ES guests

Normally guests will set up CR3 themselves, but some guests, such as
kselftests, and potentially CONFIG_PVH guests, rely on being booted
with paging enabled and CR3 initialized to a pre-allocated page table.

Currently CR3 updates via KVM_SET_SREGS* are not loaded into the guest
VMCB until just prior to entering the guest. For SEV-ES/SEV-SNP, this
is too late, since it will have switched over to using the VMSA page
prior to that point, with the VMSA CR3 copied from the VMCB initial
CR3 value: 0.

Address this by sync'ing the CR3 value into the VMCB save area
immediately when KVM_SET_SREGS* is issued so it will find it's way into
the initial VMSA.

Suggested-by: Tom Lendacky <thomas.lendacky@amd.com>
Signed-off-by: Michael Roth <michael.roth@amd.com>
Message-Id: <20211216171358.61140-10-michael.roth@amd.com>
[Remove vmx_post_set_cr3; add a remark about kvm_set_cr3 not calling the
 new hook. - Paolo]
Signed-off-by: Paolo Bonzini <pbonzini@redhat.com>