KVM: SVM: include CR3 in initial VMSA state for SEV-ES guests
Normally guests will set up CR3 themselves, but some guests, such as
kselftests, and potentially CONFIG_PVH guests, rely on being booted
with paging enabled and CR3 initialized to a pre-allocated page table.
Currently CR3 updates via KVM_SET_SREGS* are not loaded into the guest
VMCB until just prior to entering the guest. For SEV-ES/SEV-SNP, this
is too late, since it will have switched over to using the VMSA page
prior to that point, with the VMSA CR3 copied from the VMCB initial
CR3 value: 0.
Address this by sync'ing the CR3 value into the VMCB save area
immediately when KVM_SET_SREGS* is issued so it will find it's way into
the initial VMSA.
Suggested-by: Tom Lendacky <thomas.lendacky@amd.com>
Signed-off-by: Michael Roth <michael.roth@amd.com>
Message-Id: <20211216171358.61140-10-michael.roth@amd.com>
[Remove vmx_post_set_cr3; add a remark about kvm_set_cr3 not calling the
new hook. - Paolo]
Signed-off-by: Paolo Bonzini <pbonzini@redhat.com>
diff --git a/arch/x86/kvm/vmx/vmx.c b/arch/x86/kvm/vmx/vmx.c
index 1d53b814..7b5abe2 100644
--- a/arch/x86/kvm/vmx/vmx.c
+++ b/arch/x86/kvm/vmx/vmx.c
@@ -3134,6 +3134,7 @@ static void vmx_load_mmu_pgd(struct kvm_vcpu *vcpu, hpa_t root_hpa,
vmcs_writel(GUEST_CR3, guest_cr3);
}
+
static bool vmx_is_valid_cr4(struct kvm_vcpu *vcpu, unsigned long cr4)
{
/*