sh: Add SH7720 CPU support.
This adds support for the SH7720 (SH3-DSP) CPU.
Signed-off by: Markus Brunner <super.firetwister@gmail.com>
Signed-off by: Mark Jonas <toertel@gmail.com>
Signed-off-by: Paul Mundt <lethal@linux-sh.org>
diff --git a/drivers/serial/sh-sci.c b/drivers/serial/sh-sci.c
index e4abd3a..81318c5 100644
--- a/drivers/serial/sh-sci.c
+++ b/drivers/serial/sh-sci.c
@@ -4,6 +4,7 @@
* SuperH on-chip serial module support. (SCI with no FIFO / with FIFO)
*
* Copyright (C) 2002 - 2006 Paul Mundt
+ * Modified to support SH7720 SCIF. Markus Brunner, Mark Jonas (Jul 2007).
*
* based off of the old drivers/char/sh-sci.c by:
*
@@ -301,6 +302,38 @@
}
sci_out(port, SCFCR, fcr_val);
}
+#elif defined(CONFIG_CPU_SUBTYPE_SH7720)
+static void sci_init_pins_scif(struct uart_port *port, unsigned int cflag)
+{
+ unsigned int fcr_val = 0;
+ unsigned short data;
+
+ if (cflag & CRTSCTS) {
+ /* enable RTS/CTS */
+ if (port->mapbase == 0xa4430000) { /* SCIF0 */
+ /* Clear PTCR bit 9-2; enable all scif pins but sck */
+ data = ctrl_inw(PORT_PTCR);
+ ctrl_outw((data & 0xfc03), PORT_PTCR);
+ } else if (port->mapbase == 0xa4438000) { /* SCIF1 */
+ /* Clear PVCR bit 9-2 */
+ data = ctrl_inw(PORT_PVCR);
+ ctrl_outw((data & 0xfc03), PORT_PVCR);
+ }
+ fcr_val |= SCFCR_MCE;
+ } else {
+ if (port->mapbase == 0xa4430000) { /* SCIF0 */
+ /* Clear PTCR bit 5-2; enable only tx and rx */
+ data = ctrl_inw(PORT_PTCR);
+ ctrl_outw((data & 0xffc3), PORT_PTCR);
+ } else if (port->mapbase == 0xa4438000) { /* SCIF1 */
+ /* Clear PVCR bit 5-2 */
+ data = ctrl_inw(PORT_PVCR);
+ ctrl_outw((data & 0xffc3), PORT_PVCR);
+ }
+ }
+ sci_out(port, SCFCR, fcr_val);
+}
+
#elif defined(CONFIG_CPU_SH3)
/* For SH7705, SH7706, SH7707, SH7709, SH7709A, SH7729 */
static void sci_init_pins_scif(struct uart_port *port, unsigned int cflag)