MTD: remove obsolete Kconfig options
Remove the obsolete Kconfig options MTD_CFI_AMDSTD_RETRY
and MTD_CFI_AMDSTD_RETRY_MAX
The code that depended on these was removed in early 2004, but
Kconfig was not updated accordingly.
Signed-off-by: Anders Larsen <al@alarsen.net>
Signed-off-by: David Woodhouse <dwmw2@infradead.org>
Signed-off-by: Adrian Bunk <bunk@stusta.de>
diff --git a/drivers/mtd/chips/Kconfig b/drivers/mtd/chips/Kconfig
index 0f6bb2e..a7ec595 100644
--- a/drivers/mtd/chips/Kconfig
+++ b/drivers/mtd/chips/Kconfig
@@ -200,27 +200,6 @@
provides support for one of those command sets, used on chips
including the AMD Am29LV320.
-config MTD_CFI_AMDSTD_RETRY
- int "Retry failed commands (erase/program)"
- depends on MTD_CFI_AMDSTD
- default "0"
- help
- Some chips, when attached to a shared bus, don't properly filter
- bus traffic that is destined to other devices. This broken
- behavior causes erase and program sequences to be aborted when
- the sequences are mixed with traffic for other devices.
-
- SST49LF040 (and related) chips are know to be broken.
-
-config MTD_CFI_AMDSTD_RETRY_MAX
- int "Max retries of failed commands (erase/program)"
- depends on MTD_CFI_AMDSTD_RETRY
- default "0"
- help
- If you have an SST49LF040 (or related chip) then this value should
- be set to at least 1. This can also be adjusted at driver load
- time with the retry_cmd_max module parameter.
-
config MTD_CFI_STAA
tristate "Support for ST (Advanced Architecture) flash chips"
depends on MTD_GEN_PROBE