hpsa: correct abort tmf for hba devices
Aborts were not being sent down to HBA devices
Reviewed-by: Mahesh Rajashekhara <mahesh.rajashekhara@microsemi.com>
Reviewed-by: Justin Lindley <justin.lindley@microsemi.com>
Reviewed-by: Scott Teel <scott.teel@microsemi.com>
Reviewed-by: Kevin Barnett <kevin.barnett@microsemi.com>
Reviewed-by: Matthew R. Ochs <mrochs@linux.vnet.ibm.com>
Signed-off-by: Don Brace <don.brace@microsemi.com>
Signed-off-by: Martin K. Petersen <martin.petersen@oracle.com>
diff --git a/drivers/scsi/hpsa.c b/drivers/scsi/hpsa.c
index 671ad57..589b44e 100644
--- a/drivers/scsi/hpsa.c
+++ b/drivers/scsi/hpsa.c
@@ -5846,7 +5846,7 @@
}
static int hpsa_send_abort_both_ways(struct ctlr_info *h,
- unsigned char *scsi3addr, struct CommandList *abort, int reply_queue)
+ struct hpsa_scsi_dev_t *dev, struct CommandList *abort, int reply_queue)
{
/*
* ioccelerator mode 2 commands should be aborted via the
@@ -5855,14 +5855,16 @@
* Change abort to physical device reset when abort TMF is unsupported.
*/
if (abort->cmd_type == CMD_IOACCEL2) {
- if (HPSATMF_IOACCEL_ENABLED & h->TMFSupportFlags)
+ if ((HPSATMF_IOACCEL_ENABLED & h->TMFSupportFlags) ||
+ dev->physical_device)
return hpsa_send_abort_ioaccel2(h, abort,
reply_queue);
else
- return hpsa_send_reset_as_abort_ioaccel2(h, scsi3addr,
+ return hpsa_send_reset_as_abort_ioaccel2(h,
+ dev->scsi3addr,
abort, reply_queue);
}
- return hpsa_send_abort(h, scsi3addr, abort, reply_queue);
+ return hpsa_send_abort(h, dev->scsi3addr, abort, reply_queue);
}
/* Find out which reply queue a command was meant to return on */
@@ -6000,7 +6002,7 @@
cmd_free(h, abort);
return FAILED;
}
- rc = hpsa_send_abort_both_ways(h, dev->scsi3addr, abort, reply_queue);
+ rc = hpsa_send_abort_both_ways(h, dev, abort, reply_queue);
atomic_inc(&h->abort_cmds_available);
wake_up_all(&h->abort_cmd_wait_queue);
if (rc != 0) {