ARM: vexpress: Start using new Versatile Express infrastructure
This patch starts using all the configuration infrastructure.
- generic GPIO library is forced now
- sysreg GPIOs are used as MMC CD and WP information sources;
thanks to this MMCI auxiliary data is not longer necessary
- DVI muxer and mode control is removed from non-DT V2P-CA9 code
as this is now handled by the vexpress-dvi driver
- clock generators control is removed as is being handled by the
common clock driver now
- the sysreg and sysctl control is now delegated to the
appropriate drivers and all related code was removed
- NOR Flash set_vpp function has been removed as the control
bit used does _not_ control its VPP line, but the #WP signal
instead (which is de facto unusable in case of Linux MTD
drivers); this also allowed the remove its DT auxiliary
data
The non-DT code defines only minimal required number of
the config devices. Device Trees are updated to make use
of all new features.
Signed-off-by: Pawel Moll <pawel.moll@arm.com>
diff --git a/arch/arm/mach-vexpress/platsmp.c b/arch/arm/mach-vexpress/platsmp.c
index 7db27c8c..c5d70de 100644
--- a/arch/arm/mach-vexpress/platsmp.c
+++ b/arch/arm/mach-vexpress/platsmp.c
@@ -13,6 +13,7 @@
#include <linux/smp.h>
#include <linux/io.h>
#include <linux/of_fdt.h>
+#include <linux/vexpress.h>
#include <asm/smp_scu.h>
#include <asm/hardware/gic.h>
@@ -193,7 +194,7 @@
* until it receives a soft interrupt, and then the
* secondary CPU branches to this address.
*/
- v2m_flags_set(virt_to_phys(versatile_secondary_startup));
+ vexpress_flags_set(virt_to_phys(versatile_secondary_startup));
}
struct smp_operations __initdata vexpress_smp_ops = {