gpio/omap: optimise interrupt service routine
The OMAP GPIO interrupt service routine is checking each bit in the
GPIO interrupt status register to see which bits are set. It is not
efficient to check every bit especially if only a few bits are set.
Therefore, instead of checking every bit use the __ffs() function,
which returns the location of the first set bit, to find all the set
bits.
This optimisation was suggested-by and developed in collaboration
with Felipe Balbi.
Signed-off-by: Jon Hunter <jon-hunter@ti.com>
Reviewed-by: Felipe Balbi <balbi@ti.com>
Acked-by: Santosh Shilimkar <santosh.shilimkar@ti.com>
Reviewed-by: Kevin Hilman <khilman@linaro.org>
Signed-off-by: Linus Walleij <linus.walleij@linaro.org>
diff --git a/drivers/gpio/gpio-omap.c b/drivers/gpio/gpio-omap.c
index 405ce6f..f46b600 100644
--- a/drivers/gpio/gpio-omap.c
+++ b/drivers/gpio/gpio-omap.c
@@ -689,7 +689,7 @@
{
void __iomem *isr_reg = NULL;
u32 isr;
- unsigned int i;
+ unsigned int bit;
struct gpio_bank *bank;
int unmasked = 0;
struct irq_chip *chip = irq_desc_get_chip(desc);
@@ -730,9 +730,9 @@
if (!isr)
break;
- for (i = 0; isr != 0; isr >>= 1, i++) {
- if (!(isr & 1))
- continue;
+ while (isr) {
+ bit = __ffs(isr);
+ isr &= ~(1 << bit);
/*
* Some chips can't respond to both rising and falling
@@ -741,10 +741,10 @@
* to respond to the IRQ for the opposite direction.
* This will be indicated in the bank toggle_mask.
*/
- if (bank->toggle_mask & (1 << i))
- _toggle_gpio_edge_triggering(bank, i);
+ if (bank->toggle_mask & (1 << bit))
+ _toggle_gpio_edge_triggering(bank, bit);
- generic_handle_irq(irq_find_mapping(bank->domain, i));
+ generic_handle_irq(irq_find_mapping(bank->domain, bit));
}
}
/* if bank has any level sensitive GPIO pin interrupt