OMAP2: Devkit8000: Enable DVI-D output
This patch corrects the DVI-D output setup of Devkit8000
Devkit8000 has different DVI reset pin with the BeagleBoard.
On Devkit8000 the TWL4030 GPIO_7 is assigned to do the job.
Signed-off-by: Kan-Ru Chen <kanru@0xlab.org>
Signed-off-by: Tony Lindgren <tony@atomide.com>
diff --git a/arch/arm/mach-omap2/board-devkit8000.c b/arch/arm/mach-omap2/board-devkit8000.c
index a0860a9..03cb97e 100644
--- a/arch/arm/mach-omap2/board-devkit8000.c
+++ b/arch/arm/mach-omap2/board-devkit8000.c
@@ -140,13 +140,18 @@
static void devkit8000_panel_disable_lcd(struct omap_dss_device *dssdev)
{
}
+
static int devkit8000_panel_enable_dvi(struct omap_dss_device *dssdev)
{
+ if (dssdev->reset_gpio != -EINVAL)
+ gpio_set_value(dssdev->reset_gpio, 1);
return 0;
}
static void devkit8000_panel_disable_dvi(struct omap_dss_device *dssdev)
{
+ if (dssdev->reset_gpio != -EINVAL)
+ gpio_set_value(dssdev->reset_gpio, 0);
}
static int devkit8000_panel_enable_tv(struct omap_dss_device *dssdev)
@@ -186,6 +191,7 @@
.driver_name = "generic_panel",
.type = OMAP_DISPLAY_TYPE_DPI,
.phy.dpi.data_lines = 24,
+ .reset_gpio = -EINVAL, /* will be replaced */
.platform_enable = devkit8000_panel_enable_dvi,
.platform_disable = devkit8000_panel_disable_dvi,
};
@@ -272,6 +278,15 @@
devkit8000_vmmc1_supply.dev = mmc[0].dev;
devkit8000_vsim_supply.dev = mmc[0].dev;
+ /* TWL4030_GPIO_MAX + 1 == ledB, PMU_STAT (out, active low LED) */
+ gpio_leds[2].gpio = gpio + TWL4030_GPIO_MAX + 1;
+
+ /* gpio + 7 is "DVI_PD" (out, active low) */
+ devkit8000_dvi_device.reset_gpio = gpio + 7;
+ gpio_request(devkit8000_dvi_device.reset_gpio, "DVI PowerDown");
+ /* Disable until needed */
+ gpio_direction_output(devkit8000_dvi_device.reset_gpio, 0);
+
return 0;
}