uprobes/perf: Teach trace_uprobe/perf code to pre-filter
Finally implement uprobe_perf_filter() which checks ->nr_systemwide or
->perf_events to figure out whether we need to insert the breakpoint.
uprobe_perf_open/close are changed to do uprobe_apply(true/false) when
the new perf event comes or goes away.
Note that currently this is very suboptimal:
- uprobe_register() called by TRACE_REG_PERF_REGISTER becomes a
heavy nop, consumer->filter() always returns F at this stage.
As it was already discussed we need uprobe_register_only() to
avoid the costly register_for_each_vma() when possible.
- uprobe_apply() is oftenly overkill. Unless "nr_systemwide != 0"
changes we need uprobe_apply_mm(), unapply_uprobe() is almost
what we need.
- uprobe_apply() can be simply avoided sometimes, see the next
changes.
Testing:
# perf probe -x /lib/libc.so.6 syscall
# perl -e 'syscall -1 while 1' &
[1] 530
# perf record -e probe_libc:syscall perl -e 'syscall -1 for 1..10; sleep 1'
# perf report --show-total-period
100.00% 10 perl libc-2.8.so [.] syscall
Before this patch:
# cat /sys/kernel/debug/tracing/uprobe_profile
/lib/libc.so.6 syscall 79291
A huge ->nrhit == 79291 reflects the fact that the background process
530 constantly hits this breakpoint too, even if doesn't contribute to
the output.
After the patch:
# cat /sys/kernel/debug/tracing/uprobe_profile
/lib/libc.so.6 syscall 10
This shows that only the target process was punished by int3.
Signed-off-by: Oleg Nesterov <oleg@redhat.com>
1 file changed