net: dsa: mv88e6xxx: assign default FDB to ports
Restore per-port FDB. Assign them on setup, allow adding and deleting
addresses into them, and dump them.
Signed-off-by: Vivien Didelot <vivien.didelot@savoirfairelinux.com>
Signed-off-by: David S. Miller <davem@davemloft.net>
diff --git a/drivers/net/dsa/mv88e6xxx.c b/drivers/net/dsa/mv88e6xxx.c
index b4b2f05..0f06488 100644
--- a/drivers/net/dsa/mv88e6xxx.c
+++ b/drivers/net/dsa/mv88e6xxx.c
@@ -1458,14 +1458,82 @@
return _mv88e6xxx_vtu_cmd(ds, GLOBAL_VTU_OP_STU_LOAD_PURGE);
}
+static int _mv88e6xxx_port_fid(struct dsa_switch *ds, int port, u16 *new,
+ u16 *old)
+{
+ u16 fid;
+ int ret;
+
+ /* Port's default FID bits 3:0 are located in reg 0x06, offset 12 */
+ ret = _mv88e6xxx_reg_read(ds, REG_PORT(port), PORT_BASE_VLAN);
+ if (ret < 0)
+ return ret;
+
+ fid = (ret & PORT_BASE_VLAN_FID_3_0_MASK) >> 12;
+
+ if (new) {
+ ret &= ~PORT_BASE_VLAN_FID_3_0_MASK;
+ ret |= (*new << 12) & PORT_BASE_VLAN_FID_3_0_MASK;
+
+ ret = _mv88e6xxx_reg_write(ds, REG_PORT(port), PORT_BASE_VLAN,
+ ret);
+ if (ret < 0)
+ return ret;
+ }
+
+ /* Port's default FID bits 11:4 are located in reg 0x05, offset 0 */
+ ret = _mv88e6xxx_reg_read(ds, REG_PORT(port), PORT_CONTROL_1);
+ if (ret < 0)
+ return ret;
+
+ fid |= (ret & PORT_CONTROL_1_FID_11_4_MASK) << 4;
+
+ if (new) {
+ ret &= ~PORT_CONTROL_1_FID_11_4_MASK;
+ ret |= (*new >> 4) & PORT_CONTROL_1_FID_11_4_MASK;
+
+ ret = _mv88e6xxx_reg_write(ds, REG_PORT(port), PORT_CONTROL_1,
+ ret);
+ if (ret < 0)
+ return ret;
+
+ netdev_dbg(ds->ports[port], "FID %d (was %d)\n", *new, fid);
+ }
+
+ if (old)
+ *old = fid;
+
+ return 0;
+}
+
+static int _mv88e6xxx_port_fid_get(struct dsa_switch *ds, int port, u16 *fid)
+{
+ return _mv88e6xxx_port_fid(ds, port, NULL, fid);
+}
+
+static int _mv88e6xxx_port_fid_set(struct dsa_switch *ds, int port, u16 fid)
+{
+ return _mv88e6xxx_port_fid(ds, port, &fid, NULL);
+}
+
static int _mv88e6xxx_fid_new(struct dsa_switch *ds, u16 *fid)
{
+ struct mv88e6xxx_priv_state *ps = ds_to_priv(ds);
DECLARE_BITMAP(fid_bitmap, MV88E6XXX_N_FID);
struct mv88e6xxx_vtu_stu_entry vlan;
- int err;
+ int i, err;
bitmap_zero(fid_bitmap, MV88E6XXX_N_FID);
+ /* Set every FID bit used by the (un)bridged ports */
+ for (i = 0; i < ps->num_ports; ++i) {
+ err = _mv88e6xxx_port_fid_get(ds, i, fid);
+ if (err)
+ return err;
+
+ set_bit(*fid, fid_bitmap);
+ }
+
/* Set every FID bit used by the VLAN entries */
err = _mv88e6xxx_vtu_vid_write(ds, GLOBAL_VTU_VID_MASK);
if (err)
@@ -1824,7 +1892,11 @@
struct mv88e6xxx_vtu_stu_entry vlan;
int err;
- err = _mv88e6xxx_vtu_get(ds, vid, &vlan, false);
+ /* Null VLAN ID corresponds to the port private database */
+ if (vid == 0)
+ err = _mv88e6xxx_port_fid_get(ds, port, &vlan.fid);
+ else
+ err = _mv88e6xxx_vtu_get(ds, vid, &vlan, false);
if (err)
return err;
@@ -1843,10 +1915,6 @@
const struct switchdev_obj_port_fdb *fdb,
struct switchdev_trans *trans)
{
- /* We don't use per-port FDB */
- if (fdb->vid == 0)
- return -EOPNOTSUPP;
-
/* We don't need any dynamic resource from the kernel (yet),
* so skip the prepare phase.
*/
@@ -1982,10 +2050,20 @@
struct mv88e6xxx_vtu_stu_entry vlan = {
.vid = GLOBAL_VTU_VID_MASK, /* all ones */
};
+ u16 fid;
int err;
mutex_lock(&ps->smi_mutex);
+ /* Dump port's default Filtering Information Database (VLAN ID 0) */
+ err = _mv88e6xxx_port_fid_get(ds, port, &fid);
+ if (err)
+ goto unlock;
+
+ err = _mv88e6xxx_port_fdb_dump_one(ds, fid, 0, port, fdb, cb);
+ if (err)
+ goto unlock;
+
/* Dump VLANs' Filtering Information Databases */
err = _mv88e6xxx_vtu_vid_write(ds, vlan.vid);
if (err)
@@ -2286,9 +2364,13 @@
if (ret)
goto abort;
- /* Port based VLAN map: do not give each port its own address
+ /* Port based VLAN map: give each port its own address
* database, and allow every port to egress frames on all other ports.
*/
+ ret = _mv88e6xxx_port_fid_set(ds, port, port + 1);
+ if (ret)
+ goto abort;
+
reg = BIT(ps->num_ports) - 1; /* all ports */
reg &= ~BIT(port); /* except itself */
ret = _mv88e6xxx_port_vlan_map_set(ds, port, reg);