ath10k: enable firmware peer stats info for wmi tlv
For wmi tlv type, firmware disable peer stats info by default, after
enable it, firmware will report WMI_TLV_PEER_STATS_INFO_EVENTID if
ath10k send WMI_TLV_REQUEST_PEER_STATS_INFO_CMDID to firmware.
Enable it will only set a flag in firmware, firmware will not report
it without receive request WMI command.
Tested with QCA6174 SDIO with firmware WLAN.RMH.4.4.1-00042.
Signed-off-by: Wen Gong <wgong@codeaurora.org>
Signed-off-by: Kalle Valo <kvalo@codeaurora.org>
Link: https://lore.kernel.org/r/20200427080416.8265-2-wgong@codeaurora.org
diff --git a/drivers/net/wireless/ath/ath10k/wmi-tlv.c b/drivers/net/wireless/ath/ath10k/wmi-tlv.c
index e1ab900f..27aaa48 100644
--- a/drivers/net/wireless/ath/ath10k/wmi-tlv.c
+++ b/drivers/net/wireless/ath/ath10k/wmi-tlv.c
@@ -4269,6 +4269,7 @@ static struct wmi_pdev_param_map wmi_tlv_pdev_param_map = {
.arp_dstaddr = WMI_PDEV_PARAM_UNSUPPORTED,
.rfkill_config = WMI_TLV_PDEV_PARAM_HW_RFKILL_CONFIG,
.rfkill_enable = WMI_TLV_PDEV_PARAM_RFKILL_ENABLE,
+ .peer_stats_info_enable = WMI_TLV_PDEV_PARAM_PEER_STATS_INFO_ENABLE,
};
static struct wmi_peer_param_map wmi_tlv_peer_param_map = {