qlcnic: Optimize ring count validations
- Check interrupt mode at the start of qlcnic_set_channels().
- Do not validate ring count if they are not going to change.
Signed-off-by: Shahed Shaikh <shahed.shaikh@qlogic.com>
Signed-off-by: David S. Miller <davem@davemloft.net>
diff --git a/drivers/net/ethernet/qlogic/qlcnic/qlcnic_ethtool.c b/drivers/net/ethernet/qlogic/qlcnic/qlcnic_ethtool.c
index 5bacf52..1b7f3db 100644
--- a/drivers/net/ethernet/qlogic/qlcnic/qlcnic_ethtool.c
+++ b/drivers/net/ethernet/qlogic/qlcnic/qlcnic_ethtool.c
@@ -726,6 +726,11 @@
struct qlcnic_adapter *adapter = netdev_priv(dev);
int err;
+ if (!(adapter->flags & QLCNIC_MSIX_ENABLED)) {
+ netdev_err(dev, "No RSS/TSS support in non MSI-X mode\n");
+ return -EINVAL;
+ }
+
if (channel->other_count || channel->combined_count)
return -EINVAL;
@@ -734,7 +739,7 @@
if (err)
return err;
- if (channel->rx_count) {
+ if (adapter->drv_sds_rings != channel->rx_count) {
err = qlcnic_validate_rings(adapter, channel->rx_count,
QLCNIC_RX_QUEUE);
if (err) {
@@ -745,7 +750,7 @@
adapter->drv_rss_rings = channel->rx_count;
}
- if (channel->tx_count) {
+ if (adapter->drv_tx_rings != channel->tx_count) {
err = qlcnic_validate_rings(adapter, channel->tx_count,
QLCNIC_TX_QUEUE);
if (err) {
diff --git a/drivers/net/ethernet/qlogic/qlcnic/qlcnic_main.c b/drivers/net/ethernet/qlogic/qlcnic/qlcnic_main.c
index 1c18891..4fc1867 100644
--- a/drivers/net/ethernet/qlogic/qlcnic/qlcnic_main.c
+++ b/drivers/net/ethernet/qlogic/qlcnic/qlcnic_main.c
@@ -4003,16 +4003,6 @@
strcpy(buf, "Tx");
}
- if (!QLCNIC_IS_MSI_FAMILY(adapter)) {
- netdev_err(netdev, "No RSS/TSS support in INT-x mode\n");
- return -EINVAL;
- }
-
- if (adapter->flags & QLCNIC_MSI_ENABLED) {
- netdev_err(netdev, "No RSS/TSS support in MSI mode\n");
- return -EINVAL;
- }
-
if (!is_power_of_2(ring_cnt)) {
netdev_err(netdev, "%s rings value should be a power of 2\n",
buf);