mmc: sdhci: call sdhci_init() before request irq
sdhci_init() will clear all irqs and set the needed irqs. So
logically sdhci_init() should be called before request irq.
If not, some irqs may be triggled and handled wrongly. Take
the following into consideration, after request irq, if
SDIO card interrupt enabled, a sd card in the sd slot will
trigger a mass of interrupt(SDHCI_INT_CARD_INT), because at
this time, the vmmc-regulator still not restore, no voltage
supply for the sd card, so the pin of data0~data3 change and
keep low, interrupt(SDHCI_INT_CARD_INT) will rise up ceaselessly.
Due to we already reguest irq, system will be busy in handling
this endless irq, can't response to other event.
So we should call sdhci_init() before request irq in sd resume.
Signed-off-by: Haibo Chen <haibo.chen@freescale.com>
Signed-off-by: Ulf Hansson <ulf.hansson@linaro.org>
diff --git a/drivers/mmc/host/sdhci.c b/drivers/mmc/host/sdhci.c
index fbc7efd..2cadf08 100644
--- a/drivers/mmc/host/sdhci.c
+++ b/drivers/mmc/host/sdhci.c
@@ -2716,17 +2716,6 @@
host->ops->enable_dma(host);
}
- if (!device_may_wakeup(mmc_dev(host->mmc))) {
- ret = request_threaded_irq(host->irq, sdhci_irq,
- sdhci_thread_irq, IRQF_SHARED,
- mmc_hostname(host->mmc), host);
- if (ret)
- return ret;
- } else {
- sdhci_disable_irq_wakeups(host);
- disable_irq_wake(host->irq);
- }
-
if ((host->mmc->pm_flags & MMC_PM_KEEP_POWER) &&
(host->quirks2 & SDHCI_QUIRK2_HOST_OFF_CARD_ON)) {
/* Card keeps power but host controller does not */
@@ -2739,6 +2728,17 @@
mmiowb();
}
+ if (!device_may_wakeup(mmc_dev(host->mmc))) {
+ ret = request_threaded_irq(host->irq, sdhci_irq,
+ sdhci_thread_irq, IRQF_SHARED,
+ mmc_hostname(host->mmc), host);
+ if (ret)
+ return ret;
+ } else {
+ sdhci_disable_irq_wakeups(host);
+ disable_irq_wake(host->irq);
+ }
+
sdhci_enable_card_detection(host);
return ret;