iwlwifi: prepare for PAN queue/fifo assignment
PAN ucode will require a different queue assignment,
in particular queue 9 instead of 4 should be used for
commands.
This is required because the ucode will stop/start
queues 4 and 8 depending on the PAN state, since
queue 8 will be used for PAN multicast (after DTIM).
Signed-off-by: Johannes Berg <johannes.berg@intel.com>
Signed-off-by: Wey-Yi Guy <wey-yi.w.guy@intel.com>
diff --git a/drivers/net/wireless/iwlwifi/iwl-prph.h b/drivers/net/wireless/iwlwifi/iwl-prph.h
index b1f101c..5469655 100644
--- a/drivers/net/wireless/iwlwifi/iwl-prph.h
+++ b/drivers/net/wireless/iwlwifi/iwl-prph.h
@@ -306,7 +306,7 @@
* at a time, until receiving ACK from receiving station, or reaching
* retry limit and giving up.
*
- * The command queue (#4) must use this mode!
+ * The command queue (#4/#9) must use this mode!
* This mode does not require use of the Byte Count table in host DRAM.
*
* Driver controls scheduler operation via 3 means:
@@ -322,7 +322,7 @@
* (1024 bytes for each queue).
*
* After receiving "Alive" response from uCode, driver must initialize
- * the scheduler (especially for queue #4, the command queue, otherwise
+ * the scheduler (especially for queue #4/#9, the command queue, otherwise
* the driver can't issue commands!):
*/
@@ -555,8 +555,9 @@
#define IWLAGN_SCD_TRANSLATE_TBL_OFFSET_QUEUE(x) \
((IWLAGN_SCD_TRANSLATE_TBL_OFFSET + ((x) * 2)) & 0xfffc)
-#define IWLAGN_SCD_QUEUECHAIN_SEL_ALL(x) (((1<<(x)) - 1) &\
- (~(1<<IWL_CMD_QUEUE_NUM)))
+#define IWLAGN_SCD_QUEUECHAIN_SEL_ALL(priv) \
+ (((1<<(priv)->hw_params.max_txq_num) - 1) &\
+ (~(1<<(priv)->cmd_queue)))
#define IWLAGN_SCD_BASE (PRPH_BASE + 0xa02c00)