drivers: net: cpsw: use of_phy_connect() in fixed-link case
If a fixed-link DT subnode is used, the phy_device was looked up so
that a PHY ID string could be constructed and passed to phy_connect().
This is not necessary, as the device_node can be passed directly to
of_phy_connect() instead. This reuses the same codepath as if the
phy-handle DT property was used.
Signed-off-by: David Rivshin <drivshin@allworx.com>
Tested-by: Nicolas Chauvet <kwizart@gmail.com>
Tested-by: Andrew Goodbody <andrew.goodbody@cambrionix.com>
Reviewed-by: Mugunthan V N <mugunthanvnm@ti.com>
Reviewed-by: Grygorii Strashko <grygorii.strashko@ti.com>
Signed-off-by: David S. Miller <davem@davemloft.net>
diff --git a/drivers/net/ethernet/ti/cpsw.c b/drivers/net/ethernet/ti/cpsw.c
index 712bc6d75..e2fcdf1 100644
--- a/drivers/net/ethernet/ti/cpsw.c
+++ b/drivers/net/ethernet/ti/cpsw.c
@@ -2048,22 +2048,13 @@
"slave[%d] using phy-handle=\"%s\"\n",
i, slave_data->phy_node->full_name);
} else if (of_phy_is_fixed_link(slave_node)) {
- struct device_node *phy_node;
- struct phy_device *phy_dev;
-
/* In the case of a fixed PHY, the DT node associated
* to the PHY is the Ethernet MAC DT node.
*/
ret = of_phy_register_fixed_link(slave_node);
if (ret)
return ret;
- phy_node = of_node_get(slave_node);
- phy_dev = of_phy_find_device(phy_node);
- if (!phy_dev)
- return -ENODEV;
- snprintf(slave_data->phy_id, sizeof(slave_data->phy_id),
- PHY_ID_FMT, phy_dev->mdio.bus->id,
- phy_dev->mdio.addr);
+ slave_data->phy_node = of_node_get(slave_node);
} else if (parp) {
u32 phyid;
struct device_node *mdio_node;